Quantification of φ-operating range with impact of exhaust gas recirculation under low-temperature combustion mode with polyoxymethylene dimethyl ether: A perspective study

被引:14
作者
Venugopal, Inbanaathan Papla [1 ]
Balasubramanian, Dhinesh [1 ]
Rajarajan, Amudhan [2 ]
Suresh, Kiran [3 ]
机构
[1] Mepco Schlenk Engn Coll, Dept Mech Engn, Sivakasi 626005, Tamilnadu, India
[2] CK Coll Engn & Technol, Dept Mech Engn, Cuddalore 607003, Tamilnadu, India
[3] SRM Inst Sci & Technol, Green Vehicle Technol Res Ctr, Dept Automobile Engn, Kattankulathur 603203, Tamilnadu, India
关键词
LTC; HCCI; Soot-NOx trade-off; HC-CO trade-Off; PODE; IGNITION HCCI COMBUSTION; EMISSION CHARACTERISTICS; DIRECT-INJECTION; DIESEL-ENGINE; FUEL; PERFORMANCE; BIODIESEL; EGR; AUTOIGNITION; STRATEGIES;
D O I
10.1016/j.jclepro.2023.137298
中图分类号
X [环境科学、安全科学];
学科分类号
08 ; 0830 ;
摘要
Low-Temperature Combustion (LTC) especially Homogeneous charge compression ignition (HCCI) mode of combustion is a capable substitute mode of combustion to conventional diesel combustion (CDC) to provide better soot-NOx trade-off and HC-CO trade-off characteristics. The current study mainly focuses on the Exhaust Gas Recirculation (EGR) effects and equivalence ratio optimization on W20P20 (64% diesel, 16% WCO biodiesel, and 20% PODE) fuel along with exergy analysis in the HCCI mode of operation. The reason for inculcating exergy analysis in this research is to depict that low-temperature combustion provides a better heat transfer rate inside the cylinder. EGR has been varied in terms of 10%, 20%, and 30% in volume proportions along with the inlet fuel-air mixtures since, the fuel was injected through a pilot fuel injector in the inlet manifold. A novel factor in this research is considering both soot-NOx and HC-CO trade-off characteristics in optimizing the equivalence ratio with the influence of EGR over W20P20 fuel. The performance parameters such as BTE and BSEC show a mere decrement of about 6.67% and 29% of maximum with the influence of EGR while better combustion was found in terms of avoiding misfiring at a low equivalence ratio of 0.29-0.35 and knocking at a high equivalence ratio of 0.61-0.71 for W20P20 fuel. The operating range extension of the equivalence ratio was found with W20P20 fuel which further increased again with the increase in EGR addition. The emission limits of soot, NOx, CO, and HC particles were analyzed, in which the highest NOx reduction of 53% was obtained with 30% EGR irrespective of the equivalence ratio. The highest soot reduction was 61.85% with 20% EGR at a higher equivalence ratio. The highest HC reduction was 18% with 20% EGR at a lower equivalence ratio. The CO emissions seemed to reduce by 12% at a lower equivalence ratio while they increased by 47% at a higher equivalence ratio. The comparative results were studied for EGR influence with W20P20 fuel in the HCCI mode of combustion.
引用
收藏
页数:23
相关论文
共 94 条
  • [51] Combustion and emission characteristics of a direct injection diesel engine fueled with biodiesel and PODE/biodiesel fuel blends
    Liu, Haoye
    Ma, Xiao
    Li, Bowen
    Chen, Longfei
    Wang, Zhi
    Wang, Jianxin
    [J]. FUEL, 2017, 209 : 62 - 68
  • [52] Study on combustion and emission characteristics of Polyoxymethylene Dimethyl Ethers/diesel blends in light-duty and heavy-duty diesel engines
    Liu, Haoye
    Wang, Zhi
    Zhang, Jun
    Wang, Jianxin
    Shuai, Shijin
    [J]. APPLIED ENERGY, 2017, 185 : 1393 - 1402
  • [53] Performance, combustion and emission characteristics of a diesel engine fueled with polyoxymethylene dimethyl ethers (PODE3-4)/diesel blends
    Liu, Haoye
    Wang, Zhi
    Wang, Jianxin
    He, Xin
    Zheng, Yanyan
    Tang, Qiang
    Wang, Jinfu
    [J]. ENERGY, 2015, 88 : 793 - 800
  • [54] Effects of diesel/PODE (polyoxymethylene dimethyl ethers) blends on combustion and emission characteristics in a heavy duty diesel engine
    Liu, Jialin
    Wang, Hu
    Li, Ying
    Zheng, Zunqing
    Xue, Zhenzhen
    Shang, Hongyan
    Yao, Mingfa
    [J]. FUEL, 2016, 177 : 206 - 216
  • [55] An overview of polyoxymethylene dimethyl ethers as alternative fuel for compression ignition engines
    Liu, Junheng
    Wang, Lejian
    Wang, Pan
    Sun, Ping
    Liu, Haifeng
    Meng, Zhongwei
    Zhang, Lidong
    Ma, Hongjie
    [J]. FUEL, 2022, 318
  • [56] Experimental study on the auto-ignition and combustion characteristics in the homogeneous charge compression ignition (HCCI) combustion operation with ethanol/n-heptane blend fuels by port injection
    Lu Xingcai
    Hou Yuchun
    Zu Linlin
    Huang Zhen
    [J]. FUEL, 2006, 85 (17-18) : 2622 - 2631
  • [57] Development of a reduced diesel/PODEn mechanism for diesel engine application
    Lv, Delin
    Chen, Yingjie
    Chen, Yaojuan
    Guo, Xiaoyu
    Chen, Hui
    Huang, Haozhong
    [J]. ENERGY CONVERSION AND MANAGEMENT, 2019, 199
  • [58] Optical study on spray combustion characteristics of PODE/diesel blends in different ambient conditions
    Ma, Yue
    Cui, Longxi
    Ma, Xiao
    Wang, Jianxin
    [J]. FUEL, 2020, 272 (272)
  • [59] A Multi-Dimensional CFD-Chemical Kinetics Approach in Detection and Reduction of Knocking Combustion in Diesel-Natural Gas Dual-Fuel Engines Using Local Heat Release Analysis
    Maghbouli, Amin
    Shafee, Sina
    Saray, Rahim Khoshbakhti
    Yang, Wenming
    Hosseini, Vahid
    An, Hui
    [J]. SAE INTERNATIONAL JOURNAL OF ENGINES, 2013, 6 (02) : 777 - 787
  • [60] Assessment of fuel properties, engine performance and emission characteristics of outdoor grown marine Chlorella vulgaris BDUG 91771 biodiesel
    Mathimani, Thangavel
    Kumar, Tamilkolundu Senthil
    Chandrasekar, Murugesan
    Uma, Lakshmanan
    Prabaharan, Dharmar
    [J]. RENEWABLE ENERGY, 2017, 105 : 637 - 646