Physics-based modeling of homogeneous charge compression ignition engines with exhaust throttling

Homogeneous charge compression ignition (HCCI) engines create a more efficient power source for either stationary power generators or automotive applications. Due to the absence of direct actuation of ignition, HCCI based combustion control is quite challenging. For the purpose of control synthesis and design, a crank-angle based dynamic model of an HCCI engine with internal exhaust gas recirculation (EGR) is proposed in this paper. The HCCI autoignition timing is controlled by the amount of internal EGR induced by the cost effective exhaust throttling strategy. The zero dimensional single zone model is developed based on conservation of mass and energy and ideal gas law. The model is comprised of five subsystems: cylinder volume, intake, and exhaust runners along with combustion and heat-transfer models. Inputs to the model include engine speed, intake temperature, fueling rate, intake, and exhaust throttle positions. Outputs of the model contain the pressure, temperature, mass and burned gas fraction in the intake, exhaust and cylinder, air-to-fuel ratio (AFR), heat release rate, combustion phasing, and the indicated mean effective pressure (IMEP). The model is developed based on MATLAB/Simulink and validated against experimental data under steady-state and transient conditions at various intake temperatures, fueling levels, and exhaust throttle positions. Results demonstrate that by changing the exhaust throttle position, the pressure in the exhaust runner is regulated. As a result, the residual gas fraction is altered, leading to changes in mixture temperature and thus control of the HCCI combustion phasing. In the end, closed loop simulation is conducted with a linear quadratic Gaussian (LQG) controller applied to the crank-angle based model for regulation of combustion timing CA50 using exhaust throttle during load (fueling level) changes. In the future, this model can be utilized for control development and hardware in the loop (HIL) simulation.