Evaluation of residual stress reproducibility and orientation dependent fatigue crack growth in powder bed fusion stainless steel

The complex thermal gradients of additive manufacturing (AM) result in residual stress and distinctive grain morphologies that influence mechanical performance and contribute to concern regarding the fatigue properties of AM parts. In this study, residual stress, microstructure, and fatigue crack growth rate (FCGR) results were compared in AM Type 304L stainless steel produced by laser powder bed fusion (PBF) on different systems using similar process parameters. Residual stress measured in the build direction was remarkably consistent in all PBF builds. Backscatter electron large area images revealed similar grain morphologies in the different builds, all of which exhibited elongated grains in the build direction and inhomogeneous grain size and shape. Fatigue crack growth investigated both parallel and perpendicular to the build direction revealed higher measured crack growth rates in the near-threshold regime in both orientations of the PBF material compared to wrought material. The difference in near-threshold fatigue crack growth rates is attributed primarily to the influence of processing-induced residual stress quantified by the residual stress intensity factor. These values revealed consistent FCGR effects in each orientation across specimens extracted from different builds and were then used to reveal a convergence of the corrected FCGR data of all PBF and wrought specimens.