Induction plasma spheroidization of tungsten and molybdenum powders

被引：2

作者：

蒋显亮 ^{[1
]}

M.BOULOS ^{[2
]}

机构：

[1] Institute of Surface and Coatings Technology, School of Materials Science and Engineering, Central South University, Changsha 410083, China

[2] Plasma Technology Research Center, University of Sherbrooke, Sherbrooke J1K 2R1, Canada

来源：

TransactionsofNonferrousMetalsSocietyofChina | 2006年 / 01期

关键词：

tungsten; molybdenum; induction plasma; melting; spheroidization; evaporation; oxidation;

D O I：

暂无

中图分类号：

TF124 [粉末成型、烧结及后处理];

学科分类号：

080502 ;

摘要：

The melting, evaporation and oxidation behaviors as well as the solidification phenomena of tungsten and molybdenum in induction plasma were studied. Scanning electron microscopy was used to examine the morphology and the cross section of plasma-processed powders. X-ray diffraction was used to analyze the oxides formed on the particle surface of these two metals. The influence of spray chamber pressure on the spheroidization and oxidation phenomena was discussed. The results show that fewer Mo particles than W particles are spheroidized at the same powder feed rate under the same plasma spray condition although molybdenum has a lower melting point. A small fraction of tungsten is evaporized and condensed either on the surface of tungsten particles nearby or on the wall of spray chamber. Tungsten oxides were found in tungsten powder processed under soft vacuum condition. Extremely large grains form inside some spheroidized particles of tungsten powder.

引用

页码：13 / 17

页数：5

共 6 条

[1] Modeling of oxidation of molybdenum particles during plasma spray deposition
Wan, YP
Fincke, JR
Jiang, XY
Sampath, S
Prasad, V
Herman, H
[J]. METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE, 2001, 32 (03): : 475 - 481
[2] Statistical design of experiments for the spheroidization of powdered alumina by induction plasma processing
Fan, X
Gitzhofer, F
Boulos, M
[J]. JOURNAL OF THERMAL SPRAY TECHNOLOGY, 1998, 7 (02) : 247 - 253
[3] Molybdenum and tungsten coatings for x-ray targets obtained through the low-pressure plasma spraying process
Khan, AA
Labbe, JC
Grimaud, A
Fauchais, P
[J]. JOURNAL OF THERMAL SPRAY TECHNOLOGY, 1997, 6 (02) : 228 - 234
[4] Low-pressure plasma deposition of tungsten[J] . W. Cai,H. Liu,A. Sickinger,E. Muehlberger,D. Bailey,E. J. Lavernia.Journal of Thermal Spray Technology . 1994 (2)
[5] On the induction plasma deposition of tungsten metal[J] . X. L. Jiang,R. Tiwari,F. Gitzhofer,M. I. Boulos.Journal of Thermal Spray Technology . 1993 (3)
[6] Particle melting, flattening, and stacking behaviors in the induction plasma deposition of tungsten. Jiang X L, Boulos M I. Transactions of Nonferrous Metals Society of China . 2001

← 1 →