Full blended blade and endwall design of a compressor cascade

In the current state-of-the-art, high-loss flow in the endwall significantly influences compressor performance. Therefore, the control of endwall corner separation in compressor blade rows is important to consider. Based on the previous research of the Blended Blade and End Wall(BBEW) technique, which can significantly reduce corner separation, in combination with a nonaxisymmetric endwall, the full-BBEW technique is proposed in this study to further reduce the separation in endwall region. The principle of the unchanged axial passage area is considered to derive the geometric method for this technique. Three models are further classified based on different geometric characteristics of this technique: the BBEW model, Inclining-Only End Wall(IOEW) model,and full-BBEW model. The most effective design of each model is then found by performing several optimizations at the design point and related numerical investigations over the entire operational conditions. Compared with the prototype, the total pressure loss coefficient decreases by 7%–9%in the optimized full-BBEW at the design point. Moreover, the aerodynamic blockage coefficient over the entire operational range decreases more than the other models, which shows its positive effect for diffusion. This approach has a larger decrease at negative incidence angles where the intersection of the boundary layer plays an important role in corner separation. The analysis shows that the blended blade profile enlarges the dihedral angle and creates a span-wise pressure gradient to move low momentum fluid towards the mainstream. Furthermore, the inclining hub geometry accelerates the accumulated flow in the corner downstream by increasing the pressure gradient.Overall, though losses in the mainstream grow, especially for large incidences, the full-BBEW technique effectively reduces the separation in corners.