Research on mixed variable crown contour for work roll of strip mill

被引：1

作者：

Kong, Fanfu ^{[1
]}

He, Anrui ^{[1
]}

Shao, Jian ^{[1
]}

Li, Tongqing ^{[2
]}

机构：

[1] National Engineering Research Center for Advanced Rolling, University of Science and Technology Beijing

[2] Sinosteel Equipment and Engineering Co., Ltd.

来源：

Jixie Gongcheng Xuebao/Journal of Mechanical Engineering | 2012年 / 48卷 / 22期

关键词：

Profile and flatness control; Roll contour; Strip mills; Work rolls;

D O I：

10.3901/JME.2012.22.087

中图分类号：

学科分类号：

摘要：

Crown adjustment capacity of the 3-order continuously variable crown(CVC) roll is proportional to the square of strip width, which is inevitably insufficient to the need of the narrow band strip when it is employed on the wide/ultra wide strip mills. Based on a deep research of the variable crown roll's contour design theory and the lateral roll gap formation mechanism, a method that uses quadratic polynomial curves to linearize roll gap is proposed. With this method, the complete linearly variable crown contour and the mixed variable crown contour are designed, whose crown adjustment capacity is not only proportional to axial shift position of work rolls, but also proportional to strip width in the whole width range or in the desired width band respectively. Compared with CVC contour, mixed variable crown contour ensures a less difference of the roll diameter and a stronger crown adjustment capacity, suitable for both wide and narrow strip, therefore, enhancing shape adjustment capacity and the overall performance of mills.

引用

页码：87 / 92

页数：5

共 13 条

[1]

Feldmann H., Hollmann F., Beisemann G., Et al., Rolling stand with noncylindrical rolls, (1984)

[2]

Bald W., Beisemann G., Feldmann H., Et al., Continuously variable crown(CVC) rolling, Iron and Steel Engineer, 64, 3, pp. 32-40, (1987)

[3]

Seilinger A., Mayrhofer A., Kainz A., SmartCrown-a new system for improved profile & flatness control in strip mills, Steel Times International, 26, 10, pp. 11-12, (2002)

[4]

Lou Y., On the roll surface curve of the CVC rolling mill, Journal of Central South University of Technology, 26, 3, pp. 357-361, (1995)

[5]

He A., Yang Q., Chen X., Et al., Development and application of linearly variable crown work roll in hot strip mills, Chinese Journal of Mechanical Engineering, 44, 11, pp. 255-259, (2008)

[6]

Zhang J., Research on roll shape and strip shape of CVC mill, (1990)

[7]

Jiang Z., Zhu H., Wang G., Et al., The principle for designing CVC roll profile and the discussion for control model, Journal of Iron and Steel Research, 2, 1, pp. 25-30, (1990)

[8]

Zhang J., Chen X., Xu Y., Et al., Roll contour design of 4-high mill with variable crown by axial shifting, Journal of University of Science and Technology Beijing, 16, SUPPL., pp. 98-101, (1994)

[9]

Lu C., Tieu A.K., Jiang Z., A design of a third-order CVC roll profile, Journal of Material Processing Technology, 125-126, pp. 645-648, (2002)

[10]

Liu H., Zheng Z., Peng Y., Et al., Computer simulation of the roll contact pressure characteristic for 6-high CVC wide strip mill, Chinese Journal of Mechanical Engineering, 36, 8, pp. 69-73, (2000)

← 1 2 →