Study and application of smart monitoring on compressed structures based on CFRP self-sensing

被引：0

作者：

Wang, Shuyang ^{[1
]}

Xie, Guihua ^{[1
]}

Xuan, Yuan ^{[2
]}

Mao, Pengfei ^{[2
]}

Fu, Chunyu ^{[3
]}

Miao, Yonghong ^{[1
]}

机构：

[1] Faculty of Civil Engineering and Mechanics, Jiangsu University, Zhenjiang

[2] Zhenjiang Housing Safety and Seismic Technology Guidance Center, Zhenjiang

[3] Zhenjiang Guotou Real Estate Development Co., Ltd., Zhenjiang

来源：

Fuhe Cailiao Xuebao/Acta Materiae Compositae Sinica | 2025年 / 42卷 / 03期

关键词：

axial compression; carbon fiber; off-axial angle; piezoresistive effect; structural health monitoring;

D O I：

10.13801/j.cnki.fhclxb.20240701.004

中图分类号：

学科分类号：

摘要：

A novel approach to structural health monitoring of compressed structures leveraging the intelligent properties of carbon fiber Reinforced Polymer (CFRP) was investigated. Smart CFRP strips were attached to the side surfaces of the axially compressed concrete column at various angles, and the electrical resistance of these strips under both monotonic and cyclic compression at different off-axial angles were analyzed. The findings reveal that the resistance of smart CFRP strips throughout the entire monotonic loading process correlates with the changes of the monitored structure, undergoing initial gradual changes, rapid changes at middle stage, and a sharp change upon the structural failure. The resistance changes partly reverse after failure. Under cyclic loading, the resistance shows periodic variations, with the resistance changes primarily being reversible, except for a small amount of irreversible resistance that occurs during the first loading cycle. Additionally, the off-axial angle, β, significantly influences the resistance response. At β=0° and β=90°, the smart strips exhibit negative and positive piezoresistive effects, respectively; while at β=45°, they display various piezoresistive effects in different phases, with a smaller change in resistance. The practical application results confirm the applicability and efficiency of the smart CFRP strips in structural monitoring. © 2025 Beijing University of Aeronautics and Astronautics (BUAA). All rights reserved.

引用

页码：1522 / 1531

页数：9

共 31 条

[1]

ZHOU W, ZHAO W, ZHANG Y, Et al., Cluster analysis of acoustic emission signals and deformation measurement for delaminated glass fiber epoxy composites, Composite Structures, 195, pp. 349-358, (2018)

[2]

SMITH R A, NELSON L J, MIENCZAKOWSKI M J, Et al., Ultrasonic analytic-signal responses from polymer-matrix composite laminates, IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 65, 2, pp. 231-243, (2017)

[3]

BULL D J, HELFEN L, SINCLAIR I, Et al., A comparison of multi-scale 3D X-ray tomographic inspection techniques for assessing carbon fibre composite impact damage, Composites Science and Technology, 75, pp. 55-61, (2013)

[4]

FERNANDES H, ZHANG H, FIGUEIREDO A, Et al., Carbon fiber composites inspection and defect characterization using active infrared thermography: Numerical simulations and experimental results, Applied Optics, 55, 34, pp. D46-D53, (2016)

[5]

ZHOU Zhi, HE Jianping, JIA Hongwei, Et al., Full scale brillouin sensing technique based smart parallel wire stay cable, Journal of Optoelectronics·Laser, 20, 6, pp. 766-770, (2009)

[6]

TANG Y, YAO Y, CANG J., Structural and sensing performance of RC beams strengthened with prestressed near-surface mounted self-sensing basalt FRP bar, Composite Structures, 259, (2021)

[7]

DENG Langni, XIE Hong, LIU Yang, Et al., Load effect calculation and analysis of CFRP-OFBG plate embedded reinforced concrete beam, Composites Science and Engineering, 3, pp. 5-10, (2020)

[8]

ZHAO M M, DONG Y T, ZHAO Y, Et al., Monitoring of bond in FRP retrofitted concrete structures, Journal of Intelligent Material Systems and Structures, 18, 8, pp. 853-860, (2007)

[9]

TANG Y, WANG Z, SONG M., Self-sensing and strengthening effects of reinforced concrete structures with near-surfaced mounted smart basalt fibre–reinforced polymer bars, Advances in Mechanical Engineering, 8, 10, pp. 1-19, (2016)

[10]

ZHANG Zhimei, YANG Yang, Finite element analysis of the flexural fatigue performance of reinforced conerete beams reinforced with externally bonded prestressed CFRP sheets, Composites Science and Engineering, 2, pp. 44-53, (2023)

← 1 2 3 4 →