The influence of precursor solutions containing an amount of silver bismuth sulfide nanoparticles (AgBiS2 NPs) on the characteristics of CH3NH3PbI3 perovskites solar cells

The utilization of organo-metal halide perovskites as absorbers in thin-film solar cells has garnered considerable interest from the scientific community in recent times. In this study, we present the introduction of silver bismuth sulfide nanoparticles (AgBiS2 NPs) doped into perovskite thin films composed of CH3NH3PbI3 thin film. Our results demonstrate that the perovskites' morphology and structure were significantly improved. The effects of AgBiS2 NPs concentration on the optical, mechanical, and crystallographic properties of CH3NH3PbI3 perovskite thin films were investigated. The findings from the structure investigations revealed that an increase in the concentration of AgBiS2 NPs resulted in a transition from a low-crystalline to a polycrystalline structure of the perovskite thin films. An elevation in the concentration of AgBiS2 NPs from 2 to 8 mg/mL led to the development of perovskite films of superior quality, consisting entirely of PbI3 and CH3NH3. These films exhibited almost impeccable deposition, compactness, and uniformity, and their particle size reached an approximate value of 1.3 mu m. Furthermore, an increase in the optical absorption coefficient (similar to 10(5) cm(-1)) in the visible spectrum and subsequent enhancements in photoluminescence (PL) and ultraviolet-visible (UV-Vis) absorption spectroscopy serve as further evidence of the film's enhanced quality. When AgBiS2 NPs are doped into perovskites, the films' quality is significantly improved; they acquire a uniform surface morphology, an exceptional crystal structure, and enhanced light absorption, all of which contribute to accelerated PL quenching and charge transfer. Power conversion efficiency (PCE) was enhanced across all photovoltaic parameters through the use of larger granules in bulk-heterojunction solar cells, as opposed to undoped heterojunction solar cells. The PCE of the perovskite device with CH3NH3PbI3 base is 17.04 % at the optimal concentration of 6 mg/mL AgBiS2 NPs. These findings indicate that the doping of CH3NH3PbI3 perovskite thin films with AgBiS2 NPs is essential for the achievement of high crystallinity, a large particle size, and a high absorption coefficient. These properties are advantageous for the high-power conversion efficiency of solar cell applications.