Study of the Effect of Microgeometry Parameters of the Cutting Edge on Cutting Force, Wear, and Machinability during Milling

被引：0
作者：
Babaev, A.S. [1 ]
Kozlov, V.N. [1 ]
Semenov, A.R. [1 ]
Shevchuk, A.S. [1 ]
Ovcharenko, V.A. [1 ]
机构：
[1] National Research Tomsk State University, Tomsk
来源：
Russian Engineering Research | 2024年 / 44卷 / 12期
基金：
俄罗斯科学基金会;
关键词：
cutting force; microgeometry of the cutting edge; milling; roughness; wear;
D O I：
10.3103/S1068798X24703271
中图分类号：
学科分类号：
摘要：
Abstract: The article considers milling of structural steels using a tool with rounded cutting edges and wear-resistant coating. The effectiveness of drag finishing of sharpened cutters with rounded edges and cutters with rounded edges and a PVD coating is assessed based on the cutting force and efficient tool life. © Allerton Press, Inc. 2024.
引用
收藏
页码：1756 / 1766
页数：10
相关论文
共 34 条
[1]  
Pawade R.S., Joshi S.S., Brahmankar P.K., Effect of machining parameters and cutting edge geometry on surface integrity of high-speed turned Inconel 718, Int. J. Mach. Tools Manuf, 48, pp. 15-28, (2008)
[2]  
Hajdu D., Astarloa A., Kovacs I., Dombovari Z., The curved uncut chip thickness model: A general geometric model for mechanistic cutting force predictions, Int. J. Mach. Tools Manuf, 188, (2023)
[3]  
Zhou L., Peng F.Y., Yan R., Analytical modeling and experimental validation of micro end-milling cutting forces considering edge radius and material strengthening effects, Int. J. Mach. Tools Manuf, 97, pp. 29-41, (2015)
[4]  
Denkena B., Biermann D., Cutting edge geometries, CIRP Ann, 63, pp. 631-653, (2014)
[5]  
Denkena B., Koehler J., Rehe M., Influence of the honed cutting edge on tool wear and surface integrity in slot milling of 42CrMo4 steel, Procedia CIRP, 1, pp. 190-195, (2012)
[6]  
Denkena B., Michaelis A., Herrmann M., Influence of tool material properties on the wear behavior of cemented carbide tools with rounded cutting edges, Wear, 456-457, (2020)
[7]  
Fulemova J., Rehor J., Influence of form factor of the cutting edge on tool life during finishing milling, Procedia Eng, 100, pp. 682-688, (2015)
[8]  
Rech J., Yen Y.-C., Schaffet M.J., Influence of cutting edge radius on the wear resistance of PM-HSS milling inserts, Wear, 259, pp. 1168-1176, (2005)
[9]  
Denkena B., Lucas A., Bassett E., Effects of the cutting edge microgeometry on tool wear and its thermo-mechanical load, CIRP Ann, 60, pp. 73-76, (2011)
[10]  
Woon K.S., Rahman M., Fang F.Z., Neo K.S., Liu K., Investigations of tool edge radius effect in micromachining: A FEM simulation approach, J. Mater. Process. Technol, 195, pp. 204-211, (2008)
1234