An experimental investigation on the performance of a single cylinder diesel engine at various partial loads

被引：0

作者：

Hong, Thong Duc ^{[1
,2
]}

Hoang, Binh Thanh Thi ^{[1
,2
]}

Ho, Thien Quoc Mai ^{[1
,2
]}

Truong, Phat Tan ^{[1
,2
]}

Pham, Minh Quang ^{[1
,2
]}

机构：

[1] Faculty of Transportation Engineering, Ho Chi Minh City University of Technology (HCMUT), Ho Chi Minh City

[2] Vietnam National University Ho zhi Minh City (VNU-HCM), Ho Chi Minh City

来源：

Transportation Engineering | 2024年 / 18卷

关键词：

Diesel engine; Fuel consumption; Jerk pump; Partial load; Performance;

D O I：

10.1016/j.treng.2024.100288

中图分类号：

学科分类号：

摘要：

This study investigates various partial load characteristics of a diesel engine, including brake specific fuel consumption, torque, and power, to get insight into these performances in practice. Firstly, these characteristics were experimentally examined with approximate 25, 50, 75, and 85 % fuel rack settings at 900–2400 rpm engine speeds. Then, more operating modes were investigated to build characteristics corresponding to constant fuel quantity per engine cycle. The results indicate that the practical partial load characteristics significantly differ from the theory of full-load characteristics since the fuel quantity per cycle varies even though the rack is fixed. Especially at low loads, the fuel quantity per cycle increases enormously with engine speed due to the significant influence of pressure waves. Hence, torque and power increase continuously, making it challenging to control the engine operation. In contrast, because the reduction in fuel viscosity and pump efficiency balances the pressure wave effects at high loads, fuel quantity per cycle remains relatively constant, making the characteristics more similar to the theory. Besides, if fuel quantity per cycle is kept constant, the trends in partial load curves follow the theory, which can be approximately predicted. These findings reveal that considering fuel quantity per cycle is significant when studying diesel engine partial loads, notably at low loads. The study contributes a vital basis for further investigating and modeling the partial characteristics of diesel engines. Also, it is a crucial reference for estimating the suitable working conditions of engine-driven systems in practice. © 2024 The Author(s)

引用

共 32 条

[1]

Lloyd A.C., Cackette T.A., Diesel engines: environmental impact and control, J. Air Waste Manage. Assoc., 51, pp. 809-847, (2001)

[2]

Johnson T., Diesel engine emissions and their control: an overview, Platin. Met. Rev., 52, pp. 23-37, (2008)

[3]

Atadashi I.M., Aroua M.K., Aziz A.A., High quality biodiesel and its diesel engine application: a review, Renew. Sustain. Energy Rev., 14, pp. 1999-2008, (2010)

[4]

Yaqoob H., Tan E.S., Ali H.M., Ong H.C., Jamil M.A., Farooq M.U., Sustainable energy generation from plastic waste: an in-depth review of diesel engine application, Environ. Technol. Innov., 34, (2024)

[5]

Nett O., Salomon A., Experimental analysis of engine out emissions of a light-duty diesel engine during warm-up under cold start conditions, Trans. Eng., 10, (2022)

[6]

Yang R., Liu J., Liu Z., Liu J., Applying separate treatment of fuel- and air-borne nitrogen to enhance understanding of in-cylinder nitrogen-based pollutants formation and evolution in ammonia-diesel dual fuel engines, Sustain. Energy Technol. Assessments., 69, (2024)

[7]

Heywood J.B., Internal Combustion Engine Fundamentals, (2018)

[8]

Van Basshuysen R., Schafer F., Internal Combustion Engine Handbook: Basics, Components, Systems, and Perspectives, (2004)

[9]

Ramachandran E., Krishnaiah R., Venkatesan E.P., Parida S., Reddy Dwarshala S.K., Khan S.A., Asif M., Linul E., Prediction of RCCI combustion fueled with CNG and algal biodiesel to sustain efficient diesel engines using machine learning techniques, Case Stud, Therm. Eng., 51, (2023)

[10]

Manikandan G., Prabakaran R., Dhamodharan P., Kim S.C., Joshuva G.G., Boopathi M., Jegadheesan C., Performance analysis of a diesel engine using margosa oil ethyl ester-based biodiesel with diethyl ether as an oxygenated additive, Case Stud. Therm. Eng., 50, (2023)

← 1 2 3 4 →