Evaluation of CO2 leakage potential through fault instability in CO2 geological sequestration by coupled THMC modelling

A faulted saline aquifer system was simulated in a coupled thermal-hydraulic-mechanical-chemical (THMC) framework to examine the potential breaching of the caprock seal from long-term CO2 sequestration. The pH of the brines steadily dropped from 7.5 to 4.7 due to the continuous injection of scCO2 (supercritical CO2), which was caused by the rapid dissolution of calcite in the reservoir and associated fault zones, alongside alterations in the concentrations of primary and secondary minerals within the formation. The increase in pore pressure with the continuous injection of scCO2 triggered fault reactivation at 6y with the resultant leakage of CO2 along the fault. This builds CO2 saturation inside the fault at 7y to six-fold higher than pre-slip. Continuing shear reactivation and creation of reactive surface area following the initial CO2 leakage accelerates dissolution/precipitation reactions, in turn further increasing porosity and permeability of the reservoir and fault. In particular, the permeability and porosity in the fault zone were increased by only 2% and 6%, respectively - staunched by competitive feedbacks in dissolution countered by precipitation that are individually much larger. Comparison of mineral concentrations adjacent to the fault before-and-after instability revealed that the development of shear failure also promotes the transport of reactivated minerals into the fault zone. Among them, feldspar changes most significantly in later stages, dominated by dissolution with the volume fraction decreasing by 80% and increasing the aqueous concentration of K + by approximately an order of magnitude. However, secondary minerals counter this dissolution through precipitation with the volume fraction of kaolinite increasing by an order of magnitude compared with the original fraction. Finally, the evolution of the fault sealing coefficient (FS) demonstrates that the porosity and permeability exert a pivotal influence in controlling the self-sealing behavior in the basal of the fault, while the upper fault layer exhibits self-enhancing response. A notable observation is that changes in mineral ion concentrations in fault zones could be applied as a significant diagnostic signal to monitor fault stability and the potential for progress of self-sealing behavior.