PREDICTING CASE DEPTHS FOR GEARS.

被引：0
|
作者：
Sharma, V.K.
Walter, G.H.
Breen, D.H.
机构：
来源：
Product Engineering (New York) | 1979年 / 50卷 / 06期
关键词：
GEAR MANUFACTURE - Analysis - STEEL HEAT TREATMENT - Carburizing - STEEL TESTING - Hardness;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
When gears transmit torque, they are subjected to bending and contact loads which, when applied repeatedly, can cause the gears to fail by fatigue. This article outlines an analytical approach for predicting case depth requirements for carburized and hardened gears that can save as much as 30% of process time. Once the steel composition and quench rate are chosen, the best carburizing cycle is the one that develops a strength gradient such that fatigue strength will exceed applied stresses at all points on and below the surface with a reasonable level of safety.
引用
收藏
页码：49 / 52
相关论文
共 50 条
  • [31] CONFIGURATION OF GAS TURBINE GEARS.
    Hiersig, H.M.
    Sawyer's Gas Turbine International, 1977, 18 (04): : 8 - 13
  • [32] SURFACE DURABILITY OF TUFFTRIDED GEARS.
    Nanjunda Ram, C.S.
    Ramamohana Rao, A.
    Materialpruefung/Materials Testing, 1980, 22 (11): : 438 - 441
  • [33] Braking Problem in Hydrostatic Gears.
    Kopacek, Jaroslav
    Industrie-Anzeiger, 1977, 99 (16): : 271 - 276
  • [34] The daily problems of airplane gears.
    Kutzbach, K
    ZEITSCHRIFT DES VEREINES DEUTSCHER INGENIEURE, 1920, 64 : 587 - 587
  • [35] COMBATING HYSTERESIS IN PLASTIC GEARS.
    Levy, Sidney
    Levy, Lloyd E.
    Machine Design, 1980, 52 (10) : 69 - 72
  • [36] FLASH TEMPERATURE IN SPUR GEARS.
    Obata, Fumio
    Fujita, Komei
    Fujii, Masahiro
    Nippon Kikai Gakkai Ronbunshu, C Hen/Transactions of the Japan Society of Mechanical Engineers, Part C, 1986, 52 (478): : 1827 - 1832
  • [37] NOISE CONTROL IN BEVEL GEARS.
    Carlson, Donald R.
    Evans, Kenneth W.
    1600,
  • [38] Planing and Milling of Bevel Gears.
    Huljus, Friedrich
    Werkstatt und Betrieb, 1973, 106 (08): : 563 - 566
  • [39] CALCULATION OF THE WEAR OF HARMONIC GEARS.
    Ivashov, E.N.
    Nekrasov, M.I.
    1984, (04):
  • [40] EPICYCLIC REVERSE-REDUCTION GEARS.
    Anon
    Shipbuilding & marine engineering international, 1982, 105 (1257): : 127 - 128
12345