Characterization of superplastic deformation behavior of a fine grain 5083 Al alloy sheet

Superplastic deformation behavior of a fine grain 5083 Al sheet (Al-4.2 pct Mg-0.7 pct Mn, trade name FORMALL 545) has been investigated under uniaxial tension over the temperature range of 500°C to 565°C. Strain rate sensitivity values >0.3 were observed over a strain rate range of 3 × 10-5 s-1 to 1 × 10-2 s-1, with a maximum value of 0.65 at 5 × 10-4 s-1 and 565°C. Tensile elongations at constant strain rate exceeded 400 pct; elongations in the range of 500 to 600 pct were obtained under constant crosshead speed and variable strain rates. A short but rapid prestraining step, prior to a slower superplastic strain rate, provided enhanced tensile elongation at all temperatures. Under the two-step schedule, a maximum tensile elongation of 600 pct was obtained at 550°C, which was regarded as the optimum superplastic temperature under this condition. Dynamic and static grain growth were examined as functions of time and strain rate. It was observed that the dynamic grain growth rate was appreciably higher than the static growth rate and that the dynamic growth rate based on time was more rapid at the higher strain rate. Cavitation occurred during superplastic flow in this alloy and was a strong function of strain rate and temperature. The degree of cavitation was minimized by superimposition of a 5.5 MPa hydrostatic pressure during deformation, which produced a tensile elongation of 671 pct at 525°C.