A Water-based System for Ceramic Injection Moulding

被引：0
作者：
Interdisc. Res. Ctr. Mat. High P., University of Birmingham, Edgbaston, Birmingham, B15 2TT, United Kingdom [1 ]
不详 [2 ]
机构：
来源：
J. Eur. Ceram. Soc. | / 2-3卷 / 211-216期
基金：
英国工程与自然科学研究理事会;
关键词：
D O I：
暂无
中图分类号：
学科分类号：
摘要：
引用
收藏
相关论文
共 50 条
[41]   Drying kinetics of water-based ceramic suspensions for tape casting [J].
Briscoe, BJ ;
Lo Biundo, G ;
Ozkan, N .
CERAMICS INTERNATIONAL, 1998, 24 (05) :347-357
[42]   A Remote Injection Moulding Simulation System Based on the Internet and the Web [J].
H. Zhou ;
Y. Zhang ;
D. Li .
The International Journal of Advanced Manufacturing Technology, 2002, 19 :722-726
[43]   A case-based system for process design of injection moulding [J].
Kwong, CK .
INTERNATIONAL JOURNAL OF COMPUTER APPLICATIONS IN TECHNOLOGY, 2001, 14 (1-3) :40-50
[44]   Remote injection moulding simulation system based on the Internet and the Web [J].
Zhou, H ;
Zhang, Y ;
Li, D .
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY, 2002, 19 (10) :722-726
[45]   Graphene and water-based elastomers thin-film composites by dip-moulding [J].
Iliut, Maria ;
Silva, Claudio ;
Herrick, Scott ;
McGlothlin, Mark ;
Vijayaraghavan, Aravind .
CARBON, 2016, 106 :228-232
[46]   Regional temperature control in ceramic injection moulding: An approach based on cooling rate optimisation [J].
Bianchi, Maria Floriana ;
Gameros, Andres A. ;
Axinte, Dragos A. ;
Lowth, Stewart ;
Cendrowicz, Aleksander M. ;
Welch, Stewart T. .
JOURNAL OF MANUFACTURING PROCESSES, 2021, 68 :1767-1783
[47]   NON-UNIFORM SHRINKAGE IN CERAMIC INJECTION-MOULDING [J].
THOMAS, MS ;
EVANS, JRG .
BRITISH CERAMIC TRANSACTIONS AND JOURNAL, 1988, 87 (01) :22-26
[48]   Injection moulding ceramic powder - Requirements and prerequisites for plastics processors [J].
Kollenberg, W ;
von Witzleben, M .
KUNSTSTOFFE-PLAST EUROPE, 2001, 91 (09) :53-+
[49]   Diagnose - expert system for injection moulding [J].
Nedess, C. ;
Plog, J. .
Kunststoffe, German plastics, 1988, 78 (12) :39-42
[50]   The characterisation of ceramic injection moulding (CIM) pastes by capillary rheometry [J].
Draper, O ;
Blackburn, S ;
Dolman, G ;
Smalley, K ;
Griffiths, A .
1997 JUBILEE RESEARCH EVENT, VOLS 1 AND 2, 1997, :237-240
12345