Evaluating the combustion of various biomass pellets in a small heat source with underfeed pellet burner: Heat output, gas emission and ash melting behavior

被引:6
作者
Backa, Alexander [1 ]
Kantova, Nikola Cajova [1 ]
Nosek, Radovan [2 ]
Patsch, Marek [2 ]
机构
[1] Univ Zilina, Res Ctr, Univ 8215-1, Zilina 01026, Slovakia
[2] Univ Zilina, Fac Mech Engn, Dept Power Engn, Univ 8215-1, Zilina 01026, Slovakia
关键词
Agricultural pellets; Combustion air optimization; Ash sintering; Ash fusion temperature; Temperature distribution; FLUE-GAS; SINTERING CHARACTERISTICS; WHEAT-STRAW; PART; WOOD; COAL; RECIRCULATION; GASIFICATION; TECHNOLOGIES; PHOSPHORUS;
D O I
10.1016/j.joei.2024.101936
中图分类号
TE [石油、天然气工业]; TK [能源与动力工程];
学科分类号
0807 ; 0820 ;
摘要
The increasing demand for renewable energy sources has increased interest in utilizing agricultural residues as a sustainable fuel alternative for small-scale heating systems. This study examined the combustion of various agricultural pellets - wheat straw, hay, alfalfa, as well as spruce pellets - in a household underfeed 18 kW burner designed for wood pellets. The aim was to evaluate emissions and ash behavior under different air supply settings to identify the most efficient combustion conditions in terms of performance, emissions, and sintered ash formation while minimizing environmental impacts. While adjustments to the air supply could not fully prevent ash sintering, they played a crucial role in optimizing emission and performance parameters. Measurements of CO, NOx, and SO2 emissions, and temperature-related parameters such as burning bed and flame temperatures, were conducted. Altering the air supply setting led to a substantial decrease in device performance, particularly for spruce pellets, where a reduction of up to 2.6 kW was observed at the measured settings. Hay pellets exhibited a significant increase in average CO production from 7944 to 12764 mg/Nm3 and NOx from 307 to 851 mg/Nm3 with varying fan settings. For alfalfa pellets, changes in air supply resulted in higher SO2 emissions, ranging from 1479 to 1683 mg/Nm3. Upon analysis of ashes, Si, K, Ca, and Mg were identified as the predominant elements in the ash from the fuels, along with Cl, S, and P. Among the tested ashes from fuels, wheat straw had the lowest ash deformation temperature at 797.0 +/- 9.9 degrees C, in contrast to alfalfa, which had the highest at 1115.0 +/- 19.2 degrees C. These results highlight the operational challenges of burning agricultural pellets in underfeed pellet burners, particularly given that the average measured burning bed temperature exceeded 1000 degrees C in some cases.
引用
收藏
页数:17
相关论文
共 76 条
[1]   An approach of analyzing gas and biomass combustion: Positioned of flame stability and pollutant reduction [J].
Al-qazzaz, Ameer ;
Eidgah, Emadoddin Erfani Farsi ;
Alfatlawi, Ali-Wadi ;
Masroori, Ali ;
Abed, Azher M. ;
Ajam, Hossein ;
Kianifar, Ali .
RESULTS IN ENGINEERING, 2024, 23
[2]   Effect of leaching on the ash behavior of wheat straw and olive residue during fluidized bed combustion [J].
Arvelakis, S ;
Vourliotis, P ;
Kakaras, E ;
Koukios, EG .
BIOMASS & BIOENERGY, 2001, 20 (06) :459-470
[3]   Trace elements in Turkish biomass fuels: Ashes of wheat straw, olive bagasse and hazelnut shell [J].
Bakisgan, Ceren ;
Dumanli, Ahu Guemrah ;
Yurum, Yuda .
FUEL, 2009, 88 (10) :1842-1851
[4]   The behaviour of phosphorus in the flue gas during the combustion of high-phosphate fuels [J].
Beck, J ;
Unterberger, E .
FUEL, 2006, 85 (10-11) :1541-1549
[5]   Size and structural characterization of lignin-cellulosic fuels after the rapid devolatilization [J].
Biagini, E. ;
Narducci, P. ;
Tognotti, L. .
FUEL, 2008, 87 (02) :177-186
[6]   Characteristics of high heating rate biomass chars prepared under N2 and CO2 atmospheres [J].
Borrego, A. G. ;
Garavaglia, L. ;
Kalkreuth, W. D. .
INTERNATIONAL JOURNAL OF COAL GEOLOGY, 2009, 77 (3-4) :409-415
[7]  
Carvalho Lara, 2012, Small-Scale Combustion of Agricultural Biomass Fuels
[8]   Combustion characteristics of different biomass fuels [J].
Demirbas, A .
PROGRESS IN ENERGY AND COMBUSTION SCIENCE, 2004, 30 (02) :219-230
[9]  
Elbl P., 2019, EUR BIOM C EXH P, P742, DOI [10.5071/27THEUBCE2019-2BV.4.43, DOI 10.5071/27THEUBCE2019-2BV.4.43]
[10]   Combustion of wood hydrolysis residue in a 150 kW powder burner [J].
Eriksson, G ;
Kjellström, B ;
Lundqvist, B ;
Paulrud, S .
FUEL, 2004, 83 (11-12) :1635-1641