Heat transfer in injection molding of crystalline plastics

被引：0

作者：

Bai, Yu ^{[1
]}

Yin, Bo ^{[2
]}

Fu, Xia-Rong ^{[1
]}

Yang, Min-Gbo ^{[2
]}

机构：

[1] College of Chemical Engineering, Sichuan University, Chengdu, 610065 Sichuan, China

[2] College of Polymer Science and Engineering, State Key Laboratory of Polymer Materials Engineering, Sichuan University, Chengdu, 610065 Sichuan, China

来源：

Journal of Applied Polymer Science | 2006年 / 102卷 / 03期

关键词：

D O I：

暂无

中图分类号：

学科分类号：

摘要：

Journal article (JA)

引用

页码：2249 / 2253

共 50 条

[1] Heat transfer in injection molding of crystalline plastics
Bai, Yu
Yin, Bo
Fu, Xia-Rong
Yang, Min-Gbo
JOURNAL OF APPLIED POLYMER SCIENCE, 2006, 102 (03) : 2249 - 2253
[2] Book review: Injection/Transfer Molding of Thermosetting Plastics
Rubber Chem Technol, 1 (G9):
[3] INJECTION-MOLDING OF PLASTICS .2. ANALYTICAL SOLUTION OF HEAT-TRANSFER PROBLEM
JANESCHITZKRIEGL, H
RHEOLOGICA ACTA, 1979, 18 (06) : 693 - 701
[4] INJECTION MOLDING OF THERMOSETTING PLASTICS THERMOSET INJECTION MOLDING
GARDNER, HM
BURGESSH.MG
SPE JOURNAL, 1966, 22 (02): : 29 - &
[5] HEAT-TRANSFER CALCULATIONS IN CRYSTALLINE PLASTICS
GLOOR, WE
SPE TRANSACTIONS, 1963, 3 (04): : 270 - 278
[6] Heat Transfer Coefficient in Injection Molding of Polymers
Heinle, M.
Drummer, D.
INTERNATIONAL POLYMER PROCESSING, 2015, 30 (04) : 434 - 441
[7] The effect of limescale on heat transfer in injection molding
Zink, Bela
Kovacs, Jozsef Gabor
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2017, 86 : 101 - 107
[8] Metal injection molding aids plastics molding
Dealey, B
MODERN PLASTICS, 2001, 78 (08): : M3 - M3
[9] Computer modeling of the heat transfer processes in injection molding
A. A. Leshchuk
T. O. Tsysar’
V. V. Ivzhenko
Journal of Superhard Materials, 2009, 31 : 97 - 103
[10] Computer modeling of the heat transfer processes in injection molding
Leshchuk, A. A.
Tsysar', T. O.
Ivzhenko, V. V.
JOURNAL OF SUPERHARD MATERIALS, 2009, 31 (02) : 97 - 103

← 1 2 3 4 5 →