Simulation and Analysis of Forced-air Precooling of Apples with Vertical Air Supply

被引:0
作者
Jin T. [1 ,2 ]
Li B. [1 ,2 ]
Zhu Z. [3 ]
Han S. [3 ]
Wei J. [1 ,2 ]
机构
[1] Institute of Refrigeration and Cryogenics, Zhejiang University, Hangzhou
[2] Key Laboratory of Refrigeration and Cryogenic Technology of Zhejiang Province, Zhejiang University, Hangzhou
[3] Tianjin Key Laboratory of Refrigeration Technology, Tianjin University of Commerce, Tianjin
来源
Nongye Jixie Xuebao/Transactions of the Chinese Society for Agricultural Machinery | 2021年 / 52卷 / 09期
关键词
Apples; Cooling performance; Forced-air precooling; Numerical simulation; Vertical air supply;
D O I
10.6041/j.issn.1000-1298.2021.09.042
中图分类号
学科分类号
摘要
Forced-air precooling is helpful in preserving the quality of fruits and vegetables. Compared with the traditional horizontal pattern, the vertical forced-air precooling has higher cooling efficiency. Computational fluid dynamics model of vertical forced-air precooling of apples was built to analyze the influence of air-inflow velocity, air-inflow temperature and the ratio of vessel aperture area on the performance of vertical forced-air precooling. It was found that when the air-inflow velocity was increased from 0.5 m/s to 2.5 m/s, the cooling time of apple was decreased from 127 min to 90 min, the main variation of the center of apples was decreased from 0.51℃ to 0.20℃, and the weight loss rate was decreased from 0.007 86% to 0.005 70%. When the air-inflow temperature was increased from 2℃ to 6℃, the cooling time remained unchanged and the finishing temperature was close to the air supply temperature. When the opening area of box was increased from 15% to 30%, the cooling rate was almost unchanged, the pressure drop was decreased from 418 Pa to 86.8 Pa, the mean variation of the center of apples was increased from 0.73℃ to 1.11℃, and the weight loss rate was about 0.006%. Concerned with the actual situation, the optimal pre-cooling air-inflow velocity of vertical forced-air precooling was about 2.0 m/s, which was lower than that of horizontal forced-air precooling. It was advisable to adopt the smaller box opening area to ensure the structural strength if the pressure drop was acceptable. In order to reduce the weight loss rate, air should flow evenly over all apple surfaces to ensure the surface temperatures drop as quickly as possible. By comparing with the experimental data, it was found that the results obtained by the model adopted were basically consistent with the trend of the experimental results, and the maximum temperature difference did not exceed 1.5℃, which can be used to evaluate the performance of precooling with air pressure difference in vertical delivery of apples. © 2021, Chinese Society of Agricultural Machinery. All right reserved.
引用
收藏
页码:369 / 375
页数:6
相关论文
共 28 条
[1]  
HE Hongxia, SHEN Jiang, ZHU Zongsheng, Research status and development trends on precooling technology of fruits and vegetables, Food Science and Technology, 44, 2, pp. 46-52, (2019)
[2]  
DUAN Yuan, WANG Guanbang, OLANIYI A F., Postharvest precooling of fruit and vegetables: a review, Trends in Food Science & Technology, 100, 4, pp. 278-291, (2020)
[3]  
HAN Jiawei, BADIA-MELIS R, ZHAO Chunjiang, CFD simulation of airflow and heat transfer during forced-air precooling of apples, Journal of Food Process Engineering, 40, 2, pp. 230-241, (2017)
[4]  
HAN Jiawei, QIAN Jianping, ZHAO Chunjiang, Et al., Mathematical modelling of cooling efficiency of ventilated packaging: integral performance evaluation, International Journal of Heat and Mass Transfer, 111, 8, pp. 386-397, (2017)
[5]  
HAN Jiawei, ZHAO Chunjiang, QIAN Jianping, Et al., Numerical modeling of forced-air cooling of palletized apple: integral evaluation of cooling efficiency, International Journal of Refrigeration, 89, 5, pp. 131-141, (2018)
[6]  
DEFRAEYE T, LAMBRECHT R, DELELE M A, Et al., Forced-convective cooling of citrus fruit: cooling conditions and energy consumption in relation to package design, Journal of Food Engineering, 121, 2, pp. 118-127, (2014)
[7]  
WU Wentao, HALLER P, CRONJE P, Et al., Full-scale experiments in forced-air precoolers for citrus fruit: impact of packaging design and fruit size on cooling rate and heterogeneity, Biosystem Engineering, 169, 5, pp. 115-125, (2018)
[8]  
WU Wentao, DEFRAEYE T., Identifying heterogeneities in cooling and quality evolution for a pallet of packed fresh fruit by using virtual cold chains, Applied Thermal Energy, 133, 3, pp. 407-417, (2018)
[9]  
WU Wentao, CRONJE P, NICOLAI B, Et al., Virtual cold chain method to model the postharvest temperature history and quality evolution of fresh fruit-a case study for citrus fruit packed in a single carton, Computers and Electronics in Agriculture, 144, 1, pp. 199-208, (2018)
[10]  
HE Hongxia, Research on forced-air precooling technology of vertical air supply, (2019)