Multiplexing Arm Based Modular Multilevel Converter with Energy Storage

被引：0

作者：

Zeng W. ^{[1
,2
]}

Li R. ^{[2
]}

Cai X. ^{[2
]}

机构：

[1] Energy Development Research Institute of China Southern Power Grid, Guangzhou

[2] Wind Power Research Center, School of Electronic Information and Electrical Engineering, Shanghai Jiao Tong University, Shanghai

来源：

Dianli Xitong Zidonghua/Automation of Electric Power Systems | 2023年 / 47卷 / 03期

基金：

中国国家自然科学基金;

关键词：

battery energy storage; DC fault blocking; flexible DC transmission; modular multilevel converter (MMC); multiplexing arm; quasi-full-bridge submodule (QFBSM); wind farm;

D O I：

10.7500/AEPS20211129004

中图分类号：

学科分类号：

摘要：

The modular multilevel converter based high voltage direct current (MMC-HVDC) transmission technology has become an ideal solution to the integration of large-scale and remote wind farms. When the penetration rate of wind power is high, the MMC-HVDC system for wind farm integration presents low-inertia characteristics. A possible solution to improving system inertia is adding the energy storage system and the appropriate control strategy. This paper proposes a quasi-full-bridge submodule topology for the MMC with energy storage based on the multiplexing arm and studies its modulation and control strategy. The quasi-full-bridge submodule is mixed with the half-bridge submodule to reduce the cost and loss of the system. Compared with the single-stage half-bridge submodule topology, the proposed topology has significantly lower requirements on battery voltage and can smooth the battery current. Compared with the two-stage half-bridge submodule, the proposed topology has DC fault blocking capability. Finally, the simulation and experimental results verify the effectiveness of the proposed topology and the modulation and control strategies. © 2023 Automation of Electric Power Systems Press. All rights reserved.

引用

页码：177 / 186

页数：9

共 25 条

[1]

CAI Xu, YANG Renxin, ZHOU Jianqiao, Et al., Review on offshore wind power integration via DC transmission ［J］, Automation of Electric Power Systems, 45, 21, pp. 2-22, (2021)

[2]

LIANG Kai, PENG Xiaotao, QIN Shiyao, Et al., Study on synergetic control strategy for optimizing frequency response of wind farm augmented with energy storage system ［J］, Proceedings of the CSEE, 41, 8, pp. 2628-2641, (2021)

[3]

CAI Baorui, YANG Lei, HUANG Wei, Frequency coordination control of a variable speed wind turbine based on inertia/droop control［J］, Power System Protection and Control, 49, 15, pp. 169-177, (2021)

[4]

YANG R X, SHI G, CAI X, Et al., Autonomous synchronizing and frequency response control of multi-terminal DC systems with wind farm integration ［J］, IEEE Transactions on Sustainable Energy, 11, 4, pp. 2504-2514, (2020)

[5]

CHEN Pengwei, QI Chenchen, CHEN Xin, Et al., Frequency response modeling and parameter identification of doubly-fed wind farm with additional frequency control［J］, Transactions of China Electrotechnical Society, 36, 15, pp. 3293-3307, (2021)

[6]

LIU Zhongjian, ZHOU Ming, LI Zhaohui, Et al., Review of inertia control technology and requirement evaluation in renewable-dominant power system ［J］, Electric Power Automation Equipment, 41, 12, pp. 1-11, (2021)

[7]

JIANG Huilan, CAI Jizhao, XIAO Rui, Et al., A wind-storage coordinated control strategy for improving system frequency response characteristics ［J］, Electric Power Automation Equipment, 41, 7, pp. 44-51, (2021)

[8]

YAN Xiangwu, CHANG Wenfei, Primary frequency regulation control strategy of doubly-fed induction generator considering supercapacitor SOC feedback adaptive adjustment ［J］, Transactions of China Electrotechnical Society, 36, 5, pp. 1027-1039, (2021)

[9]

ZENG W，, LI R，, CAI X., A new hybrid modular multilevel converter with integrated energy storage［J］, IEEE Access, 7, pp. 172981-172993, (2019)

[10]

KAWAKAMI N, KON H, Et al., Development of a 500-kW modular multilevel cascade converter for battery energy storage systems ［J］, IEEE Transactions on Industry Applications, 50, 6, pp. 3902-3910, (2014)

← 1 2 3 →