Numerical and experimental analysis of stress and strains in flat ends of high-pressure vessels

被引：10

作者：

Szybiñski B. ^{[1
]}

Romanowicz P. ^{[1
]}

Zieliñski A.P. ^{[1
]}

机构：

[1] Institute of Machine Design, Cracow University of Technology, 31-155 Kraków

来源：

Key Engineering Materials | 2011年 / 490卷

关键词：

experimental analysis; finite element method; flat ends; Pressure vessels; stress relief groove;

D O I：

10.4028/www.scientific.net/KEM.490.226

中图分类号：

学科分类号：

摘要：

Application of flat welded ends with stress relief grooves in high-pressure vessels is a common alternative to use of dished vessel ends. It is well established and follows calculation rules given in codes: EN-12952-3 [1], EN-13445-3 [2], or in ASME code [3]. However the calculation rules do not give any definite answer what should be the choice of parameters defining a circular stress relief groove, for example, position of the groove and its radius. Usually the choice of them relies on engineering practice. The present paper clearly shows the influence of this choice on stress concentration in the cylinder-endplate junction area. The results of numerical study are verified in experimental investigations performed for a cylindrical high-pressure vessel. © 2012 Trans Tech Publications, Switzerland.

引用

页码：226 / 236

页数：10

共 13 条

[1]

Water-tube boilers and auxiliary installations, Design and Calculation of Pressure Parts, (2001)

[2]

2202, Unfired Pressure Vessels-Part 3: Design

[3]

Rao K.R., Companion Guide to the ASME Boiler and Pressure Vessel Code, (2006)

[4]

Preiss R., Stress concentration factors of flat end to cylindrical shell connection with a fillet or stress relief groove subjected to internal pressure, International Journal of Pressure Vessels and Piping, 73, 3, pp. 183-190, (1997)

[5]

Preiss R., Rauscher F., Vazda D., Zeman J.L., The flat end to cylindrical shell connection-limit load and creep design, Int. J. Press. Vessel and Piping, 75, pp. 715-726, (1998)

[6]

Vilhelmsen T., Reference stress solutions of flat end to cylindrical shell connection and comparison with design stresses predicted by codes, International Journal of Pressure Vessels and Piping, 77, 1, pp. 35-39, (2000)

[7]

Laczek, Ry J., Zieliski A.P., Load capacity of thick-walled cylinder with radial hole, Int. J. Press. Vessel and Piping, 87, pp. 433-439, (2010)

[8]

Widlak G., Local Shakedown Analysis of Thick-walled Reactor Subject to Mechanical and Thermal Loads, (2010)

[9]

Mrzyglod M., Zieliski A.P., Low-cycle fatigue constraints in two-stage structural optimization of a nozzle to pressure vessel connection, CIMNE Barcelona, (2009)

[10]

Szybiski B., Trojnacki A., Experimental Verification of Strength Calculations of Highpressure Metal B-type Sealing (In Polish), (2010)

← 1 2 →