Fatigue, Corrosion-Fatigue and SCC of AISI 304 Stainless Steel Fully-Threaded Stud Bolts

被引：0

作者：

Nery, Macclarck Pessoa ^{[1
]}

Nascimento, Brenno Lima ^{[1
]}

Reis, Matheus Mariano da Silva ^{[1
]}

de Jesus, Ihana Gabriela Conceicao ^{[1
]}

Griza, Sandro ^{[1
]}

Martins, Carlos Otavio Damas ^{[1
]}

机构：

[1] Univ Fed Sergipe, Ave Marcelo Deda Chagas S-N, BR-49100000 Sao Cristovao, SE, Brazil

来源：

JOURNAL OF FAILURE ANALYSIS AND PREVENTION | 2024年 / 24卷 / 06期

关键词：

Fatigue; Corrosion-fatigue; Stress corrosion cracking; Fully-threaded stud bolts; AISI; 304; AUSTENITIC STAINLESS-STEEL; ROOM-TEMPERATURE; CHLORIDE CONTENT; MEAN STRESS; BEHAVIOR; CRACKING; FREQUENCY; STRENGTH; STRAIN; DEFORMATION;

D O I：

10.1007/s11668-024-02055-w

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

This study reports the behavior of a fully-threaded stud bolt made of AISI 304 stainless steel under the following conditions: fatigue, corrosion-fatigue, and stress corrosion cracking (SCC). The fatigue tests at ambient temperature were conducted at frequencies of 2 and 30 Hz, considering a endurance fatigue limit of 2x10(6) cycles. In situ corrosion-fatigue tests were performed in an aqueous solution of 35 g/L NaCl at 2 Hz, and finally, the in situ stress corrosion cracking tests lasted for 278 hours under constant stress. The results showed that higher mean stress and frequency reduce the strength of this component. In the tests conducted in the chloride solution, the synergistic effect of fatigue and the environment caused a reduction in the component's strength compared to the air tests. In terms of aggressiveness, the loading conditions can be classified as corrosion-fatigue > fatigue > SCC, as no stress corrosion cracking failures were observed in this component under the tested conditions.

引用

页码：2969 / 2978

页数：10

共 55 条

[1] Effect of sensitization on corrosion fatigue behavior of type 304 stainless steel annealed in nitrogen gas [J].

Akita, Masayuki ;

Uematsu, Yoshihiko ;

Kakiuchi, Toshifumi ;

Nakajima, Masaki ;

Tsuchiyama, Toshihiro ;

Bai, Yu ;

Isono, Kenta .

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2015, 640 :33-41

[2] Strain-Induced Martensite Formation and Recrystallization Behavior in 304 Stainless Steel [J].

Al-Fadhalah, Khaled J. .

JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE, 2015, 24 (04) :1697-1709

[3] The effect of test temperature on SCC behavior of austenitic stainless steels in boiling saturated magnesium chloride solution [J].

Alyousif, Osama M. ;

Nishimura, Rokuro .

CORROSION SCIENCE, 2006, 48 (12) :4283-4293

[4] Fatigue and corrosion-fatigue strength of hot rolled Ti35Nb2.5Sn alloy [J].

Azevedo, Thiago Figueiredo ;

Celestino de Andrade, Carlos Eduardo ;

dos Santos, Silvando Vieira ;

Silva, Abraao Santos ;

Griza, Sandro .

MATERIALS & DESIGN, 2015, 85 :607-612

[5] Studies of the tensile and corrosion fatigue behaviour of austenitic stainless steels [J].

Begum, Zahida ;

Poonguzhali, A. ;

Basu, Ranita ;

Sudha, C. ;

Shaikh, H. ;

Rao, R. V. Subba ;

Patil, Awanikumar ;

Dayal, R. K. .

CORROSION SCIENCE, 2011, 53 (04) :1424-1432

[6]

Boniardi, 2014, STAINLESS STEEL, P232

[7] THE EFFECT OF MEAN STRESS ON THE FATIGUE LIMIT OF HIGH-TENSILE BOLTS [J].

BURGUETE, RL ;

PATTERSON, EA .

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE, 1995, 209 (04) :257-262

[8] Fatigue failure of the bolts connecting a Francis turbine with the shaft [J].

Casanova, Fernando ;

Mantilla, Carlos .

ENGINEERING FAILURE ANALYSIS, 2018, 90 :1-13

[9]

Collins J.A., 1981, FAILURE MAT MECH DES

[10] Optimization of Bolted Joints: A Literature Review [J].

Croccolo, Dario ;

De Agostinis, Massimiliano ;

Fini, Stefano ;

Khan, Muhammad Yasir ;

Mele, Mattia ;

Olmi, Giorgio .

METALS, 2023, 13 (10)

← 1 2 3 4 5 6 →