Mechanical behavior and bearing capacity calculation of self-stressing steel slag aggregate reinforced concrete filled circular steel tube columns

被引：0

作者：

Fang Y. ^{[1
]}

Yu F. ^{[1
]}

Zhang Y. ^{[1
]}

Xu L. ^{[1
]}

Wang X. ^{[1
]}

机构：

[1] School of Civil Engineering and Architecture, Anhui University of Technology, Ma'anshan

来源：

Fuhe Cailiao Xuebao/Acta Materiae Compositae Sinica | 2020年 / 37卷 / 05期

关键词：

Bearing capacity; Concrete; Mechanical behavior; Self-stressing; Steel slag aggregate; Steel tube; Stress-strain;

D O I：

10.13801/j.cnki.fhclxb.20190916.001

中图分类号：

学科分类号：

摘要：

To study the mechanical mechanism of self-stressing steel slag aggregate reinforced concrete filled circular steel tube (steel slag aggregate/concrete@circular steel tube) columns, eight specimens including six short columns and two intermediate length columns were designed for axial compression test, the variable parameters, such as the diameter-thickness ratio, expansion rate of steel slag aggregate concrete and length-diameter ratio were considered. The whole failure process of specimens was observed, and then the strain-stress curves as well as the peak stress was obtained. The influence of variable parameters on the mechanical behavior of self-stressing steel slag aggregate/concrete@circular steel tube columns was analyzed. Test results indicate that the short columns under axial load exhibit shear failure while the intermediate length columns experience global flexural buckling failure mode. The stress-strain curves of all specimens are basically similar, which undergo the peak point, descending section, slow rise section and so on. The peak strain and peak stress of all specimens are significantly increased compared with those of common steel slag aggregate concrete, and the improvement effects are more obvious in short columns than those in intermediate length columns. According to the limit equilibrium condition and entire process analysis, the calculation formula of bearing capacity of self-stressing steel slag aggregate/concrete@circular steel tube columns was proposed, and then the stress-strain model of self-stressing steel slag aggregate/concrete@circular steel tube columns was established depending on the experimental data. The theoretical calculation results are in good agreement with test data. The research results can provide reference for further research and engineering application of self-stressing steel slag aggregate/concrete@circular steel tube columns. © 2020, Editorial Office of Acta Materiae Compositae Sinica. All right reserved.

引用

页码：1211 / 1220

页数：9

共 21 条

[1]

JU Y, LIU H B, LIU J H, Et al., Investigation on thermophysical properties of reactive powder concrete[J], Technological Sciences, 54, 12, pp. 3382-3403, (2011)

[2]

ZHU Y G, LU M D, CHENG Y, Et al., Research progress on resource utilization of steel slag in China, Iron & Steel Scrap of China, 4, pp. 25-29, (2007)

[3]

ZHAO J H, YAN P Y., Volume stability and stabilization treatment of steel slag in China[J], Bulletin of the Chinese Ceramic Society, 36, 2, pp. 477-483, (2017)

[4]

JUCKES L M., The volume stability of modern steelmaking slags[J], Mineral Processing and Extractive Metallurgy, 112, 3, pp. 177-197, (2003)

[5]

QASRAWI H, SHALABI F, ASI I., Use of low CaO unprocessed steel slag in concrete as fine aggregate, Construction and Building Materials, 23, 2, pp. 1118-1125, (2009)

[6]

WANG G, WANG Y, GAO Z., Use of steel slag as a granular material: Volume expansion prediction and usability criteria[J], Journal of Hazardous Materials, 184, 1-3, pp. 555-560, (2010)

[7]

ZHANG T S, LIU F T, WANG J W, Et al., Recent development of steel slag stability and activating activity, Bulletin of the Chinese Ceramic Society, 26, 5, pp. 980-984, (2007)

[8]

GAO B, LI C H., Study on the expansion mechanism and inhibition method of steel slag, Iron& Steel Scrap of China, 2, pp. 28-31, (2011)

[9]

LIU H, WANG Y X, HE M H, Et al., Strength and ductility performance of concrete-filled steel tubular columns after long-term service loading[J], Engineering Structures, 100, pp. 308-325, (2015)

[10]

LAI M H, HO J C M., A theoretical axial stress-strain model for circular concrete filled-steel-tube columns, Engineering Structures, 125, pp. 124-143, (2016)

← 1 2 3 →