Enhancement of physico-mechanical and electrochemical properties of zinc-rich epoxy coatings by optimised interfacial behaviour of reduced graphene oxide

被引:0
|
作者
Wang, Peng [1 ]
Wei, Jian [1 ]
Lv, Enhao [1 ]
Miao, Zhuang [1 ]
Zhang, Yanbin [1 ]
Li, Yuerong [1 ]
机构
[1] Xian Univ Architecture & Technol, Coll Mat Sci & Engn, Xian, Peoples R China
基金
中国国家自然科学基金;
关键词
Reduced graphene oxide; Zinc rich epoxy coating; Mechanical properties; Cathodic protection; Interfacial effects; CORROSION PROTECTION PERFORMANCE; POWDER COATINGS; CARBON NANOTUBES; STEEL; NANOCOMPOSITE; RESISTANCE; WATER; CLAY; EIS;
D O I
10.1016/j.diamond.2024.111815
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
High porosity and low utilization of zinc powder are two major challenges for conventional zinc-rich epoxy (ZRE) coatings. Although these two challenges can be overcome by the addition of graphene material, it also brings new challenges due to the addition of more fillers leading to degradation of mechanical properties and galvanic coupling corrosion. In this work, the effect of the interfacial behaviour of reduced graphene oxide (RGO) in coatings on the mechanical properties, shielding properties and cathodic protection properties of RGO/ZRE composite coatings has been comprehensively evaluated. In terms of mechanical properties, RGO additions of 0.3 wt%, 0.75 wt% and 1.2 wt% exhibited RGO enhancement stage, RGO interfacial compatibility influence stage and RGO agglomeration influence stage. In terms of cathodic protection performance, RGO additions of 0.3 wt%, 0.75 wt% and 1.2 wt% exhibited a zinc powder utilization enhancement stage, an accelerated zinc powder consumption stage by galvanic coupling corrosion, and a significantly reduced initial shielding stage, respectively. The RGO/ZRE composite coating has the best comprehensive performance at 0.3 wt% RGO addition, and the composite coating did not crack or peel off in impact and bending tests, the coefficient of friction was 0.64465, the width of abrasion mark was 1.18 mm, and the coating adhesion was 5.81 MPa. The 0.3 wt%-RGO/ ZRE composite coating has insignificant galvanic coupling corrosion and has a cathodic protection time of 720 h, and significantly higher low-frequency impedance modulus than the ZRE coatings. The shielding, mechanical, and cathodic protection properties of ZRE coatings can be significantly improved with appropriate RGO additions, and the galvanic coupling corrosion and agglomeration induced by the high RGO content are the key factors limiting the application of RGO in the coatings.
引用
收藏
页数:12
相关论文
共 50 条
  • [31] Electrochemical corrosion behaviour of zinc and zinc-reduced graphene oxide coatings on mild steel in 3.5% NaCl solution
    Dharanendra, R. A.
    Prakash, M. Shet
    Sreenivasa, S.
    Shivakumara, S.
    BULLETIN OF MATERIALS SCIENCE, 2022, 45 (03)
  • [32] Electrochemical corrosion behaviour of zinc and zinc-reduced graphene oxide coatings on mild steel in 3.5% NaCl solution
    R A Dharanendra
    M Shet Prakash
    S Sreenivasa
    S Shivakumara
    Bulletin of Materials Science, 45
  • [33] Study of physico-mechanical properties of epoxy coatings modified with liquid rubbers with terminal carboxyl group
    Rudakova, E. V.
    Kovzhina, A. L.
    Evtyukov, N. Z.
    Mashlyakovskii, L. N.
    Tverdov, A. I.
    Otvalko, Zh. A.
    Fomin, S. E.
    Ushakova, E. S.
    RUSSIAN JOURNAL OF APPLIED CHEMISTRY, 2013, 86 (11) : 1760 - 1766
  • [34] GO-Ti3C2 two-dimensional heterojunction nanomaterial for anticorrosion enhancement of epoxy zinc-rich coatings
    Shen, Lu
    Zhao, Wenjie
    Wang, Kui
    Xu, Jianguang
    JOURNAL OF HAZARDOUS MATERIALS, 2021, 417
  • [35] A Comparative Study on Mechanical Properties of Yttrium Oxide and Reduced Graphene Oxide Reinforced Epoxy Nanocomposites
    Singh, Pooja
    Sharma, Swati
    Kumar, Kaushal
    Iyer, Ganesh
    Kumar, Arun
    JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE, 2025, 34 (05) : 3706 - 3716
  • [36] Influence of fiber surface treatments on physico-mechanical behaviour of jute/epoxy composites impregnated with aluminium oxide filler
    Swain, Priyadarshi Tapas Ranjan
    Biswas, Sandhyarani
    JOURNAL OF COMPOSITE MATERIALS, 2017, 51 (28) : 3909 - 3922
  • [37] Effect of graphene oxide nanosheets on the physico-mechanical properties of chitosan/bacterial cellulose nanofibrous composites
    Azarniya, Amir
    Eslahi, Niloofar
    Mahmoudi, Nafiseh
    Simchi, Abdolreza
    COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 2016, 85 : 113 - 122
  • [38] Graphene oxide-enriched double network hydrogel with tunable physico-mechanical properties and performance
    Mohammadi, Sepideh
    Keshvari, Hamid
    Eskandari, Mahnaz
    Faghihi, Shahab
    REACTIVE & FUNCTIONAL POLYMERS, 2016, 106 : 120 - 131
  • [39] Design alternate epoxy-reduced graphene oxide/epoxy-zinc multilayer coatings for achieving long-term corrosion resistance for Cu
    Ge, Tianhao
    Zhao, Wenjie
    Wu, Xuedong
    Wu, Yangmin
    Shen, Lu
    Ci, Xiaojing
    He, Yanlin
    MATERIALS & DESIGN, 2020, 186 (186)
  • [40] CeO2 modified graphene nanoplatelets composite powders enhanced the cathodic protection of waterborne zinc-rich epoxy coatings
    Wang, Chunyu
    Qin, Zhaohui
    Feng, Kang
    Zhong, Bo
    JOURNAL OF POLYMER RESEARCH, 2020, 27 (12)