Renewable power energy management for single and three-phase inverters design

This study manages solar panels, wind turbines, and fuel cells to develop single- and three-phase Sinusoidal Pulse Width Modulation (SPWM) inverter circuits. The maximum power point tracking method in direct current (DC)DC boost converters efficiently uses these renewable sources. Photovoltaic (PV), wind turbines, fuel cells, and bidirectional batteries are utilized in energy management. Efficiency, material cost reduction, and user convenience depend on energy management. The technology fully charges the standby battery when all sources are available. Other renewable sources will power the system if one fails. Before boost converter circuits, renewable energies generated 310 V for PV, 60 V for wind energy conversion, 215 V for fuel cells, and 25.9 V for bidirectional batteries. Proportional-integral (PI) controllers govern inverter switching to maintain high-quality sinusoidal outputs while decreasing total harmonic distribution (THD). Single-phase load voltage and current at resistive load have 0.65419 % THD. Load voltage and current root main square (RMS) values are 217.3617 (V) and 3.1052 (A), respectively. When connected to an R load, the three-phase inverter circuit provides 1.5146 % THD for load voltage and current. Load voltage and current RMS readings are 218.4261 (V) and 2.1843 (A). THD is 1.5969 % for load voltage and 1.2905 % for load current with an RL load. In this example, load voltage and current RMS values are 214.201 (V) and 2.0916 (A). Simulations demonstrate the successful integration of renewable sources to meet energy needs and maintain power supply. The above solutions use renewable energy efficiently and integrate with the grid.