Thermo-mechanical analysis of rubber compounds filled by carbon nanotubes

被引：1

作者：

Koštial, P. ^{[1
]}

Bakošová, D. ^{[2
]}

Jančíková, Z. ^{[1
]}

Ružiak, I. ^{[1
]}

Valíček, J. ^{[1
]}

机构：

[1] Faculty of Industrial Technologies in Púchov, University of Alexander Dubcek in Trenčín

来源：

Defect and Diffusion Forum | 2013年 / 336卷

关键词：

Heat transfer; Mechanical properties of polymers;

D O I：

10.4028/www.scientific.net/DDF.336.1

中图分类号：

学科分类号：

摘要：

The presented work is devoted to the investigation of the influence of single wall carbon nanotubes (SWCNT) on the thermal and mechanical properties of rubber blends. The materials under investigation were rubber blends filled by carbon black (CB-labelled as standard or S) or a mixture of CB with single wall carbon nanotubes (0.6 wt.% of SWCNT). The thermal parameters of the rubber samples were measured on the basis of an exponential model of a cooling body (developed in a lumped capacity model). From the measured cooling curve of the sample after its deformation, the specific heat capacity cp [J/kg/K], thermal diffusivity α [m2/s] and thermal conductivity k [W/m/K] were measured. The increase of α and k was observed for rubber blends filled with a mixture of CB and SWCNT. The complex thermo mechanical analyzer (CTMA) was used for determination of thermal and mechanical parameters. The static Young's modulus shows an immense increase after SWCNT addition. The dynamic Young's modulus also shows an increase after SWCNT introduction. A simultaneous tgδ decrease caused by SWCNT presence is observed in this case. © (2013) Trans Tech Publications, Switzerland.

引用

页码：1 / 10

页数：9

共 11 条

[1]

Akoshima M., Baba T., Thermal Diffusivity Measurements of Candidate Reference Materials by the Laser Flash Method, (2003)

[2]

Gaal P.S., Thermitus M.A., Stroe D.E., Journal of Thermal Analysis and Calorimetry, 78, (2004)

[3]

Knappe S., Blumm J., From Light Flash to Heat Transfer of Polymers, (2004)

[4]

Kostial P., Kopal I., Mokrysova M., Hutyra J., Contact-less Measurements of Thermal Parameters in Low Conductive Dielectric Materials, (2005)

[5]

Dewitt D.P., Bergman T.L., Lavine A.S., Incropera F.P., Fundamentals of Heat and Mass Transfer, pp. 260-261, (2007)

[6]

Schwaigen B., Niedermaier W., Reinforcing Filler System in Rubber - A Bright Future, (2003)

[7]

Weiss Z., Simha-Martynkova G., Sustai O., Nanostruktura Uhlikatých Materiálů, (2005)

[8]

Dierkes W.K., Economic Mixing of Silica-Rubber Compounds, (2005)

[9]

Kostial P., Ruziak I., Jonsta Z., International Journal of Thermophysics, 31, (2010)

[10]

Heger M., Spicka I., Bogar M., Strnavova M., Franz J., Simulation of Technological Processes Using Hybrid Technique Exploring Mathematical-physical Models and Artificial Neural Network, (2011)

← 1 2 →