Cyclic testing of exterior beam-column joints with varying joint aspect ratio

被引:0
作者
机构
[1] Chun, Sung-Chul
[2] Shin, Yeong-Soo
来源
| 1600年 / American Concrete Institute卷 / 111期
关键词
Reinforcement - Hysteresis - Joints (structural components) - Shear flow - Anchorages (foundations);
D O I
10.14359/51686730
中图分类号
学科分类号
摘要
To examine the effects of joint aspect ratio (beam depth to column depth ratio) on shear strength and required amount of transverse reinforcement in exterior beam-column joints, 14 joint specimens were tested under reversed cyclic loading. The main experimental parameters were the joint aspect ratio, the amount of transverse reinforcement, and the anchorage types of beam bars (hooked and headed bars). The test results indicate that, for a joint aspect ratio equal to or less than 1.0, all joints showed typical flexural behavior. Even transverse reinforcement was reduced to two-thirds of the transverse reinforcement required by ACI 352R-02; the hysteretic behavior and strengths of the joints were similar to those of the joints designed in accordance with ACI 352R-02. For a joint aspect ratio equal to or greater than 2.0, nominal strengths of joints could not be developed and joint shear failure occurred where the requirements of ACI 352R-02 were satisfied. From the analysis of measured shear strengths of the joints, it is suggested that the shear strength factor of ACI 352R-02 is reduced as the joint aspect ratio increases, if the joint aspect ratio is higher than 1.65. The test results also indicate that there was no significant difference between anchorage types of hooked or headed bars. © 2014, American Concrete Institute.
引用
收藏
相关论文
共 50 条
[31]   Seismic performance of exterior R/C beam-column joint under varying axial force [J].
Hu, Yanbing ;
Maeda, Masaki ;
Suzuki, Yusuke ;
Jin, Kiwoong .
STRUCTURAL ENGINEERING AND MECHANICS, 2021, 78 (05) :623-635
[32]   Verification of Experimental Hysteresis Loops for Exterior Beam-Column Joint Under Lateral Cyclic Load [J].
Hadi, N. D. ;
Hamid, N. H. .
2ND INTERNATIONAL CONFERENCE ON AGRICULTURAL TECHNOLOGY, ENGINEERING AND ENVIRONMENTAL SCIENCES, 2021, 644
[33]   Performance Evaluation of Metallic and Synthetic Fiber Hybridization on the Cyclic Behavior of Exterior Beam-Column Joint [J].
Chidambaram, R. Siva ;
Agarwal, Pankaj .
ADVANCES IN CIVIL ENGINEERING MATERIALS, 2018, 7 (01) :381-402
[34]   Effects of joint aspect ratio on required transverse reinforcement of exterior joints subjected to cyclic loading [J].
Chun, Sung Chul .
EARTHQUAKES AND STRUCTURES, 2014, 7 (05) :705-718
[35]   Ultimate moment of reinforced concrete exterior beam-column joint [J].
Kusuhara, Fumio ;
Shiohara, Hitoshi .
Journal of Structural and Construction Engineering, 2013, 78 (693) :1949-1958
[37]   Study on Cyclic Response of Circular Spiral Confined Exterior Beam-Column Joints with Welded Wire Fabric [J].
Asha, P. ;
Sundararajan, R. .
IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY-TRANSACTIONS OF CIVIL ENGINEERING, 2021, 45 (01) :99-110
[38]   An experimental study for effectiveness of steel fibre reinforced exterior beam-column joints under cyclic resistance [J].
Patel, Priti ;
Desai, Atul ;
Bid, Soumita ;
Desai, Pranav .
CONSTRUCTION AND BUILDING MATERIALS, 2024, 411
[39]   CYCLIC BEHAVIOR OF EXTERIOR NON-CONFORMING RC BEAM-COLUMN JOINTS WITH PLAIN AND DEFORMED BARS [J].
De Risi, Maria Teresa ;
Ricci, Paolo ;
Verderame, Gerardo Mario .
IRF2016: 5TH INTERNATIONAL CONFERENCE INTEGRITY-RELIABILITY-FAILURE, 2016, :965-984
[40]   Evolution of the yield penetration and bond stress in RC exterior beam-column joints under cyclic loading [J].
Gao, Xiangling ;
Peng, Honglu ;
Li, Jie .
STRUCTURES, 2022, 36 :703-718