High-pressure thermal conductivity, speed of ultrasonic measurements and derived elastic modulus of sandstones with different porosity

The effect of pressure on thermal conductivity is an important for understanding the heat transfer processes in modeling applications in geothermal reservoirs and for optimization of the technology of geothermal energy extraction processes. The primary factors affecting the economics of any geothermal energy recovery process are the amount of heat present in the geothermal reservoir and rate of heat extraction, which strongly depend on the thermal properties of the reservoir rocks, which are functions of both temperature and pressure. The present paper aims to study the variation of thermal conductivity of five sandstone samples from the Germany Geothermal Field with various total (open and close) porosities of (6.8, 13.0, 15.44, 21.3, and 21.5%) with pressure up to 203 MPa, to overcome the existing lack of thermal conductivity data for the geothermal reservoir modeling. The improved steady-state heat-flow technique (contact method) was used to precisely (with an uncertainty of 4%) measure the thermal conductivity of the sandstone samples. Unlike previous studies, in the present work the effect of the contact thermal resistance on the measured values of thermal conductivity has been taken into account using a calibration procedure to increase the accuracy and reliability of the measured data. The results show that with the increase of the pressure at a fixed temperature of 293.15 K, the thermal conductivity of sandstone is linearly increasing with pressure from 0.52 to 1.73 GPa(-1) depending on sandstone structural and mineralogical composition, porosity, and other characteristics, which falls in the same range reported by other authors for rock samples from different geothermal fields. The derived values of the thermal conductivity pressure coefficient are crucial for geothermal studies in order to effectively use the geothermal resources of the region, and are useful for scientific applications such as the development and testing of the accuracy, reliability, and predictive capability of existing thermal models of geothermal reservoirs. Based on the present experimental results, statistical analysis (correlation analysis) was revealed between the measured thermal conductivity of sandstone samples and open and close porosities. The role of closed and open porosities on the pressure dependence of thermal conductivity and elastic moduli is discussed. For the first time, we experimentally observed the difference of the influence of the open and closed porosities on the thermal conductivity and elastic properties of sandstones. It was experimentally confirmed that the effect of closed porosity on the thermal conductivity of sandstones is significantly greater than that of open porosity by 15 to 20%. The obtained results show that it is of great importance to study the changes in the thermal properties of the sandstones under pressure at realistic reservoir conditions for geothermal studies.