Surface morphology and electrical characteristics of direct fluorinated epoxy-resin/alumina composite

被引:0
|
作者
Li C. [1 ]
He J. [1 ]
Hu J. [1 ]
机构
[1] State Key Laboratory of Power Systems, Department of Electrical Engineering, Tsinghua University, Beijing
来源
IEEE Trans Dielectr Electr Insul | / 5卷 / 3071-3077期
关键词
dc surface flashover; direct fluorination; Epoxy resins; HVDC GIL;
D O I
10.1109/TDEI.2016.7736871
中图分类号
学科分类号
摘要
As basic insulating material, epoxy resins are widely used as the matrix of insulators in HVDC transmission system. In most cases, alumina of micro range is blended to improve mechanical properties as well as reduce expenses, etc. However, apart from benefits, the incorporation of micro-particles could alter surface electric behaviors due to the change in material structures and the surface trap distribution under operating condition. Therefore, the surface charge behavior under dc is changed as well, which can affect the surface flashover characteristic. Direct fluorination is a method to change surface properties by introducing stable C-F structure to the surface of the dielectric material. The newly formed fluorinated layer could bring changes to electrical characteristics, thus affecting surface electrical properties under dc stress. In this paper, samples are prepared using alumina casted epoxy resin composites. The two parts are blended using the same process used to produce cone-type insulators in gasinsulated substations (GIS) in industrial application. Experiment samples were treated with F2/N2 mixture containing 12.5% F2 in volume at 50 °C under 0.1MPa. The scanning electron microscopy (SEM) and fourier transform infrared spectroscopy (FTIR) were used to investigate surface physicochemical characteristics. Water and diiodomethane droplet contact angles were measured and surface energies were calculated. The distribution of the surface voltage potential, as well as the surface conductivity and DC flashover voltage were measured. Experiment results confirmed that the fluorination to epoxy resin and alumina composites can change the surface morphology by changing the exposed area of surface alumina particles. It also showed that fluorinated samples have higher DC flashover voltage in both air and SF6 due to the combined effect of the change in the surface morphology and the surface conductivity. © 2016 IEEE.
引用
收藏
页码:3071 / 3077
页数:6
相关论文
共 50 条
  • [31] ON PREPARATION OF COMPOSITE METAL MOLDS FOR CASTING EPOXY-RESIN PLATES
    SHISHLOV, AD
    INDUSTRIAL LABORATORY, 1965, 31 (11): : 1749 - &
  • [32] THE EFFECT OF THE VISCOSITY OF EPOXY PREPOLYMER ON THE GENERATED MORPHOLOGY IN RUBBER-TOUGHENED EPOXY-RESIN
    KIM, SC
    KO, MB
    JO, WH
    POLYMER, 1995, 36 (11) : 2189 - 2195
  • [33] Thermomechanical properties and morphology of blends of a novel thermoplastic copolymer and epoxy-resin
    Blanco, I
    Cicala, G
    LoFaro, C
    Recca, A
    JOURNAL OF POLYMER ENGINEERING, 2003, 23 (03) : 163 - 176
  • [34] THE MORPHOLOGY AND FRACTURE-BEHAVIOR OF A MISCIBLE EPOXY-RESIN POLYETHERIMIDE BLEND
    CHEN, MC
    HOURSTON, DJ
    SUN, WB
    EUROPEAN POLYMER JOURNAL, 1995, 31 (02) : 199 - 201
  • [35] Thermomechanical properties and morphology of blends of a novel thermoplastic copolymer and epoxy-resin
    Blanco, I.
    Cicala, G.
    LoFaro, C.
    Recca, A.
    Journal of Polymer Engineering, 2003, 23 (03): : 163 - 176
  • [36] Thermal and electrical properties of aluminum nitride filled epoxy-resin compound
    Konzelmann, Simon
    Hoffmann, Christian
    Merte, Ralf
    Peier, Dirk
    IEEE TRANSACTIONS ON DIELECTRICS AND ELECTRICAL INSULATION, 2008, 15 (02) : 327 - 333
  • [37] Thermal and electrical properties of aluminum nitride filled epoxy-resin compound
    Merte, Ralf
    Konzelmann, Simon
    Peier, Dirk
    PROCEEDINGS OF THE 10TH INTERNATIONAL CONFERENCE ON OPTIMIZATION OF ELECTRICAL AND ELECTRONIC EQUIPMENT, VOL I: ELECTROTECHNICS, 2006, : 111 - 116
  • [38] THE MECHANISM OF THE ACCELERATED DICY CURE OF EPOXY-RESIN SYSTEMS FOR ELECTRICAL APPLICATIONS
    JACKSON, RJ
    PIGNERI, AM
    GALGOCI, EC
    SAMPE JOURNAL, 1987, 23 (06) : 16 - 20
  • [39] Mesoporous MFI zeolite material from silica-alumina/epoxy-resin composite material and its catalytic activity
    Fujiwara, Masahiro
    Sakamoto, Akinori
    Shiokawa, Kumi
    Patra, Astam K.
    Bhaumik, Asim
    MICROPOROUS AND MESOPOROUS MATERIALS, 2011, 142 (01) : 381 - 388
  • [40] STUDY OF FRACTURE PROPERTIES AND MORPHOLOGY OF PURE EPOXY-RESIN AND EPOXY-CARBON FIBER COMPOSITES
    MIJOVIC, J
    KOUTSKY, JA
    BULLETIN OF THE AMERICAN PHYSICAL SOCIETY, 1978, 23 (03): : 385 - 385