Surface morphology and electrical characteristics of direct fluorinated epoxy-resin/alumina composite

被引:0
|
作者
Li C. [1 ]
He J. [1 ]
Hu J. [1 ]
机构
[1] State Key Laboratory of Power Systems, Department of Electrical Engineering, Tsinghua University, Beijing
来源
IEEE Trans Dielectr Electr Insul | / 5卷 / 3071-3077期
关键词
dc surface flashover; direct fluorination; Epoxy resins; HVDC GIL;
D O I
10.1109/TDEI.2016.7736871
中图分类号
学科分类号
摘要
As basic insulating material, epoxy resins are widely used as the matrix of insulators in HVDC transmission system. In most cases, alumina of micro range is blended to improve mechanical properties as well as reduce expenses, etc. However, apart from benefits, the incorporation of micro-particles could alter surface electric behaviors due to the change in material structures and the surface trap distribution under operating condition. Therefore, the surface charge behavior under dc is changed as well, which can affect the surface flashover characteristic. Direct fluorination is a method to change surface properties by introducing stable C-F structure to the surface of the dielectric material. The newly formed fluorinated layer could bring changes to electrical characteristics, thus affecting surface electrical properties under dc stress. In this paper, samples are prepared using alumina casted epoxy resin composites. The two parts are blended using the same process used to produce cone-type insulators in gasinsulated substations (GIS) in industrial application. Experiment samples were treated with F2/N2 mixture containing 12.5% F2 in volume at 50 °C under 0.1MPa. The scanning electron microscopy (SEM) and fourier transform infrared spectroscopy (FTIR) were used to investigate surface physicochemical characteristics. Water and diiodomethane droplet contact angles were measured and surface energies were calculated. The distribution of the surface voltage potential, as well as the surface conductivity and DC flashover voltage were measured. Experiment results confirmed that the fluorination to epoxy resin and alumina composites can change the surface morphology by changing the exposed area of surface alumina particles. It also showed that fluorinated samples have higher DC flashover voltage in both air and SF6 due to the combined effect of the change in the surface morphology and the surface conductivity. © 2016 IEEE.
引用
收藏
页码:3071 / 3077
页数:6
相关论文
共 18 条
  • [11] Comparative study on direct fluorination and surface properties of alumina-filled and unfilled epoxy insulators
    An, Zhenlian
    Yang, Wei
    Xing, Zhaoliang
    Chen, Weijun
    Chen, Kang
    Gao, Wenjian
    Shen, Zihan
    Yang, Yong
    Liu, Fang
    Liu, Xulei
    Zhang, Zhuo
    IEEE TRANSACTIONS ON DIELECTRICS AND ELECTRICAL INSULATION, 2020, 27 (01) : 85 - 93
  • [12] Surface Charge Decay of Epoxy Resin Treated by AP-DBD Deposition and Direct Fluorination
    Zhang, Cheng
    Ma, Yiyang
    Kong, Fei
    Wang, Ruixue
    Ren, Chengyan
    Shao, Tao
    IEEE TRANSACTIONS ON DIELECTRICS AND ELECTRICAL INSULATION, 2019, 26 (03) : 768 - 775
  • [13] Hydrophobicity, Surface Charge and DC Flashover Characteristics of Direct-fluorinated RTV Silicone Rubber
    Du, B. X.
    Li, Z. L.
    IEEE TRANSACTIONS ON DIELECTRICS AND ELECTRICAL INSULATION, 2015, 22 (02) : 934 - 940
  • [14] Promotion of Epoxy Resin Surface Electrical Insulation Performance and Its Stability by Atmospheric Fluorocarbon Dielectric Barrier Discharge
    Chen, Xingyu
    Chen, Sile
    Zhang, Bo
    Li, Guoqiang
    Chang, Zhengshi
    Zhang, Guan-Jun
    IEEE TRANSACTIONS ON DIELECTRICS AND ELECTRICAL INSULATION, 2020, 27 (06) : 1973 - 1981
  • [15] Surface Charge and DC Flashover Characteristics of Direct-fluorinated SiR/SiO2 Nanocomposites
    Du, B. X.
    Li, Z. L.
    IEEE TRANSACTIONS ON DIELECTRICS AND ELECTRICAL INSULATION, 2014, 21 (06) : 2602 - 2610
  • [16] Composite membranes based on fully sulfonated poly(aryl ether ketone)/epoxy resin/different curing agents for direct methanol fuel cells
    Na, Tianyi
    Shao, Ke
    Zhu, Jing
    Sun, Hongcheng
    Xu, Dan
    Zhang, Zhuoqi
    Lew, Christopher M.
    Zhang, Gang
    JOURNAL OF POWER SOURCES, 2013, 230 : 290 - 297
  • [17] Atmospheric pressure plasmas and direct fluorination treatment of A2O3-filled epoxy resin: A comparison of surface charge dissipation
    Zhang, Cheng
    Ma, Yiyang
    Kong, Fei
    Yan, Ping
    Chang, Chao
    Shao, Tao
    SURFACE & COATINGS TECHNOLOGY, 2019, 362 : 1 - 11
  • [18] Surface modification of spherical silica micro-powder using silane coupling agents and their application in epoxy resin-based composite materials
    Wang, Daobei
    Yu, Mingdong
    Wang, Yining
    Yao, Zhiqiang
    Xia, Anqi
    Li, Lin
    Wang, Dongzhi
    Journal of Applied Polymer Science, 1600, 141 (24):