Effect of installation position of ultrasonic flowmeter probe on flow measurement

被引：1

作者：

Zheng D. ^{[1
]}

Zhang P. ^{[1
]}

Xu T. ^{[1
]}

机构：

[1] School of Electrical Engineering and Automation, Tianjin University

来源：

Jixie Gongcheng Xuebao/Journal of Mechanical Engineering | 2011年 / 47卷 / 12期

关键词：

Dry calibration; Numerical simulation; Ultrasonic flowmeter; Ultrasonic probe;

D O I：

10.3901/JME.2011.12.013

中图分类号：

学科分类号：

摘要：

An existing problem in the dry calibration method for the ultrasonic flowmeter is the effect of installation position of ultrasonic probe on the flow measurement. In order to solve this problem, a numerical simulation method based on computational fluid dynamics is proposed. Firstly, experiments are carried out to study the quantitative effect of ultrasonic flowmeter probe position on measurement. And the simulation model is created and optimized based on experiment results. Secondly, two typical installations-protrusion and recess-are discussed respectively. Through analyzing the flow mechanism of flow field, the velocity distribution along each acoustic path, and the variation of flow field at the probe, the effect law of probe installation position on the flow measurement and the produced measurement errors are obtained. Comparison between the two installation positions shows that the probe protrusion achieves a better measurement result, so it is recommended as an optimal installation position. © 2011 Journal of Mechanical Engineering.

引用

页码：13 / 18

页数：5

共 10 条

[1]

Measurement of gas by multipath ultrasonic meters, (1998)

[2]

Walsh J.T., A report of acoustic transit time accuracy field work performed in North America, The 5th International Conference on Hydraulic Efficiency Measurements, pp. 21-29, (2004)

[3]

Xiong G., New technology of natural gas ultrasonic flow rate measurement, Natural Gas and Oil, 2, 20, pp. 57-61, (2002)

[4]

Drenthen J.G., Boer G., The manufacturing of ultrasonic gas flow meters, Flow Measurement and Instrumentation, 12, pp. 89-99, (2001)

[5]

Walsh J.T., ASME PTC 18-2002 Hydraulic turbines and pump-turbines, (2002)

[6]

Voser A., CFD-Calculations of the protrusion effect and impact on the acoustic discharge measurement accuracy

[7]

Lowell F., Schafer S., Walsh J., Acoustic flowmeters in circular pipes: Acoustic transducer and conduit protrusion effects in discharge measurement

[8]

Renaldas R., Investigation of the flow velocity profile in a metering section of an invasive ultrasonic flowmeter, Flow Measurement and Instrumentation, 17, pp. 201-206, (2006)

[9]

Xu Y., Yu Z., Zhang T., Et al., Influence of key factors on discharge coefficient in V-cone flowmeter, Chinese Journal of Mechanical Engineering, 44, 12, pp. 105-111, (2008)

[10]

Hou Y., Yao J., Zeng D., Et al., Development and calibration of a hyperstatic six-component force/torque sensor, Chinese Journal of Mechanical Engineering, 22, 4, pp. 505-513, (2009)

← 1 →