Improvement of the contact fatigue strength by rolling of sintered ferrous alloy rolle -2nd Report

被引：0

作者：

Miura H. ^{[1
]}

Tsumori F. ^{[1
]}

Hamamoto S. ^{[2
]}

Komoto K. ^{[2
]}

Unami S. ^{[3
]}

机构：

[1] Dept. Mechanical Engineering, Kyushu University, Nishi-ku, Fukuoka 819-0395

[2] Dept. Intelligent Machinery and Systems, Graduate of School Kyushu University, Nishi-ku, Fukuoka 819-0395

[3] JFE Steel Corporation, Chuou-ku, Chiba 260-0835

来源：

Funtai Oyobi Fummatsu Yakin/Journal of the Japan Society of Powder and Powder Metallurgy | 2010年 / 57卷 / 06期

关键词：

Case hardening; Contact fatigue strength; Fatigue damage mechanism; Ferrous alloy compacts; Rolling;

D O I：

10.2497/jjspm.57.430

中图分类号：

学科分类号：

摘要：

Due to the continual improvements of powder metallurgy techniques, it is possible for sintered materials to compete the wrought materials even in some of the most demanding applications. However, strength of sintered materials was normally inadequacy, because they have a lot of pores. This paper describes a study on the effects of the amount of rolling and effective hardened depth by case hardening on the contact fatigue strength of sintered ferrous alloy compacts and the contact fatigue damage mechanisms. Porosity at the vicinity of the surfaces of rolled compacts was decreased with increasing the amount of radial feed, from which the contact fatigue strength of rolled compacts was improved. Furthermore rolling contact fatigue strength of rolled and case hardened compacts was more improved.

引用

页码：430 / 434

页数：4

共 6 条

[1]

Strehl R., Tragfähigkeit von Zahnrädern Aus Hochfesten Sinterstählen, (1997)

[2]

Skoglund P., Kejzelman M., Hauer I., High density pm components by high velocity compaction, Powder Metallurgy, 44, pp. 199-201, (2001)

[3]

Koide T., Oda S., Nakamura H., Onishi M., Effect of sintering process and rolling on surface durability of sintered metal gears, Trans. Jpn. Soc. Mech. Eng., C, 66, pp. 2383-2387, (2000)

[4]

Miuram H., Osadam T., Hamamotom S., Komotom K., Tsuchihashim N., Unami S., Improvement of the contact fatigue strength by rolling of sintered ferrous alloy roller -1st report, J. Jpn. Soc. Powder Powder Metallurgy, 56, pp. 325-329, (2009)

[5]

Ishibashi A., Yoshino H., Nakashima I., Appreciable increase in load carrying capacity in rolling and sliding contact: For 180H-B carbon steel, Trans. Jpn. Soc. Mech. Eng., 42, pp. 2207-2214, (1976)

[6]

Smith J.O., Liu C.K., Iii U., Stresses due to tangential and normal loads on an elastic solid with application to some contact stress problems, Transactions of ASME, J. of Applied Mechanics, 20, pp. 157-166, (1953)

← 1 →