Surface free energy of basalt and glass fibers by contact angle method

被引:0
|
作者
School of Materials Science and Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100083, China [1 ]
机构
来源
Beijing Hangkong Hangtian Daxue Xuebao | 2007年 / 11卷 / 1349-1352期
关键词
Adhesion - Basalt - Composite materials - Contact angle - Dispersions - Glass fibers;
D O I
暂无
中图分类号
学科分类号
摘要
The surface free energies and their dispersion/polar components of basalt and glass fiber were investigated using dynamic contact angle analysis. According to Fowkes' and Good's theory, by making use of the contact angle values for monofiber surfaces and standard liquids with known values of surface energy, surface free energy values as well as their components of both fibers were evaluated. It was found that the surface free energy of sized basalt fiber was higher than sized S-2 glass fiber while the polar component of both fibers tended to decrease without sizing; the liquid polarity also influenced the quantity of polar interactions as well as the quantity of dispersion interactions. These results indicate that sizing on the fiber improves wettability and interface adhesion between fibers and resin in fiber reinforced composites.
引用
收藏
相关论文
共 50 条
  • [31] Surface characterization of glass fibers made from silicate waste:: Zeta-potential and contact angle measurements
    Bismarck, A
    Boccaccini, AR
    Egia-Ajuriagojeaskoa, E
    Hülsenberg, D
    Leutbecher, T
    JOURNAL OF MATERIALS SCIENCE, 2004, 39 (02) : 401 - 412
  • [32] Sizing and finishing agents for basalt and glass fibers
    E. A. Ivashchenko
    Theoretical Foundations of Chemical Engineering, 2009, 43 : 511 - 516
  • [33] Sizing and finishing agents for basalt and glass fibers
    Ivashchenko, E. A.
    THEORETICAL FOUNDATIONS OF CHEMICAL ENGINEERING, 2009, 43 (04) : 511 - 516
  • [34] Crystallization mechanism of basalt glass fibers in air
    Manylov, Mikhail S.
    Gutnikov, Sergey I.
    Pokholok, Konstantin V.
    Lazoryak, Bogdan I.
    Lipatov, Yakov V.
    MENDELEEV COMMUNICATIONS, 2013, 23 (06) : 361 - 363
  • [35] Influence of Technology Conditions on the Surface Energy of Porous Silicon Using the Method of Contact Angle
    Pastukhov, Andrei I.
    Belorus, Anton O.
    Bukina, Yaroslava V.
    Spivak, Yulia M.
    Moshnikov, Vyacheslav A.
    PROCEEDINGS OF THE 2017 IEEE RUSSIA SECTION YOUNG RESEARCHERS IN ELECTRICAL AND ELECTRONIC ENGINEERING CONFERENCE (2017 ELCONRUS), 2017, : 1183 - 1185
  • [36] Simultaneous determination of surface energy and roughness of dense membranes by a modified contact angle method
    Han, Bingjun
    Liang, Shuai
    Wang, Bo
    Zheng, Jianzhong
    Xie, Xing
    Xiao, Kang
    Wang, Xiaomao
    Huang, Xia
    COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2019, 562 : 370 - 376
  • [37] NF membranes characterisation: Relating performance (flux and rejection) with surface properties (contact angle and surface free energy)
    Nada, T.
    Hodgkiess, T.
    EUROMEMBRANE CONFERENCE 2012, 2012, 44 : 1468 - 1469
  • [38] Contact Angle Measurements of Cellulose based Thin Film composites: wettability, surface free energy and surface hardness
    Rbihi, Sara
    Aboulouard, Abdelkhalk
    Laallam, Latifa
    Jouaiti, Ahmed
    SURFACES AND INTERFACES, 2020, 21
  • [39] Ranking proposed models for attaining surface free energy of powders using contact angle measurements
    Ahadian, Samad
    Mohseni, Mohsen
    Moradian, Siamak
    INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES, 2009, 29 (04) : 458 - 469
  • [40] A comparison of different methods to calculate the surface free energy of wood using contact angle measurements
    Gindl, M
    Sinn, G
    Gindl, W
    Reiterer, A
    Tschegg, S
    COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2001, 181 (1-3) : 279 - 287