Milling induced residual stresses in structural parts out of forged aluminium alloys

被引：31

作者：

Denkena, B. ^{[1
]}

de Leon, L. ^{[1
]}

机构：

[1] Institute of Production Engineering and Machine Tools, Leibniz Universität Hannover, Hannover, Garbsen 30823

来源：

International Journal of Machining and Machinability of Materials | 2008年 / 4卷 / 04期

关键词：

Aluminium; Machining operations; Residual stress; Tool geometry;

D O I：

10.1504/IJMMM.2008.023717

中图分类号：

学科分类号：

摘要：

Machining operations of aluminium structural parts are typically carried out under high feeds and high cutting speeds. These cutting conditions exert thermal and mechanical loads on the workpiece, which cause changes in the subsurface material. Residual stresses belong to the machining induced changes and can lead to considerable rejection rates as a consequence of part distortion. Due to the significant economic importance, it is essential to investigate the influence of the machining process on the residual stresses in aluminium. This paper presents the influence of cutting parameters and tool geometry on the level of residual stress in workpieces out of forged aluminium alloys. Copyright © 2008, Inderscience Publishers.

引用

页码：335 / 344

页数：9

共 15 条

[1]

Andrae P., Hochleistungszerspanung von Aluminumknetlegierungen, (2002)

[2]

Bouzid Sai W., Et al., Influence of machining by finishing milling on surface characteristics, International Journal of Machine Tools and Manufacture, 41, 3, (2001)

[3]

Brinksmeier E., Et al., Residual stresses - measurement and causes in machining processes, Annals of the CIRP, 31, 2, (1982)

[4]

Cappello E., Davoli P., The influence of turning parameters on residual stress, International Conference on Residual Stress, (2000)

[5]

Denkena B., Breidenstein B., de Leon-Garcia L., Influence of cutting parameters on residual stresses of aluminum structural parts, High Speed Machining, (2006)

[6]

Denkena B., Breidenstein B., de Leon-Garcia L., Influence of high performance cutting on distortion of aluminum structural parts due to residual stress, High Performance Cutting, (2006)

[7]

Denkena B., de Leon-Garcia L., Kohler J., Bearbeitungsinduzierte Eigenspannungen beim Fräsen von Aluminum und Titan, Neue Fertigungstechnologien für die Luft- und Raumfahrt, (2005)

[8]

Denkena B., Schnadt-Kirschner R., Groppe M., Adaptation of the high-performance milling process, High Speed Machining, (2003)

[9]

Gey C., Prozessauslegung für das Flankenfräsen von Titan, (2002)

[10]

Groppe M., Prozessauslegung für die Hochleistungsfräsbearbeitung von Aluminum-Strukturbauteilen, (2005)

← 1 2 →