Analysis and optimization of aluminum strip during flattening process of 2450 cold rolling mill

被引：0

作者：

Liang, Meng ^{[1
]}

Yang, Hai-Bo ^{[1
]}

机构：

[1] School of Mechanical Engineering, University of Science and Technology Beijing, Beijing

来源：

Gongcheng Kexue Xuebao/Chinese Journal of Engineering | 2015年 / 37卷

关键词：

Aluminum strip; Cold rolling; Flattening machine; Strip shape;

D O I：

10.13374/j.issn2095-9389.2015.s1.017

中图分类号：

学科分类号：

摘要：

The flattening machine made the aluminum strip perform repeatedly stretch bending deformation before cold rolling process. The flattening process has a vital influence on strip rolling process by improving plate shape and residual stress distribution of the strip in the same time. In this paper, the flattening process was researched by finite element method software Abaqus according to a five roll flattening machine. In order to describe behaviors and principles of the flattening process, a series of new definitions and descriptions were put forward. Based on numbers of simulation of different kinds of shape defects and systemic analysis, relations between the effect of flattening and different degrees of plastic deformation were discussed. The results show that the best flatness parameter is decided by the shape of itself. © All right reserved.

引用

页码：103 / 107

页数：4

共 4 条

[1]

Yu C., Study on overlap of flattening roll of aluminum strip cold rolling mill, Nonferrous Met Process, 2, (2007)

[2]

Liu Q.S., To determine the working principle and parameter of flattening roller in aluminum strip cold rolling mill roll flattening, Light Alloy Fab Technol, 4, (1983)

[3]

Li T.Q., Chen X.L., Wang J.G., Mechanical analysis of tension loss in bending and straightening process, Heavy Machinery, (1999)

[4]

Gao Z.W., Guo J.L., Parameters selection of mechanical properties and process control in tension levelling line used for aluminium strip, Light Alloy Fab Technol, 32, (2004)

← 1 →