Optimization design and test of vortex pump based on CFD orthogonal test

被引：0

作者：

Gao, Xiongfa ^{[1
]}

Shi, Weidong ^{[1
]}

Zhang, Desheng ^{[1
]}

Zhang, Qihua ^{[1
]}

Fang, Bo ^{[2
]}

机构：

[1] Research Center of Fluid Machinery Engineering and Technology, Jiangsu University

[2] Jiangsu Shangbaoluo Pump Industry Co., Ltd.

来源：

Nongye Jixie Xuebao/Transactions of the Chinese Society for Agricultural Machinery | 2014年 / 45卷 / 05期

关键词：

Numerical simulation; Orthogonal experiment; Structure parameters; Vortex pump;

D O I：

10.6041/j.issn.1000-1298.2014.05.016

中图分类号：

学科分类号：

摘要：

In order to acquire the main structure parameters impacting on performance of vortex pump and optimize the performance of the vortex pump, the orthogonal testing method was introduced. Impeller outer diameter D2, blade number Z, width of blade b2, impeller outlet blade angle β2 and impeller inlet blade angle β1 were chosen to be the main factors. So 16 sets of programs with 16 type of impellers were designed according to L16(45) orthogonal table. Optimum value range of each factor was preliminarily obtained through range analysis. Quadratic orthogonal test was conducted to investigate the effects of main factors and acquire the primary and secondary factors of the design parameters on the vortex pump, and an optimization scheme for further design was obtained. The internal flow field and experimental results of optimization scheme were compared with the original model, and it showed that pump inlet produced two back-flows with different degree; the back-flow loss of optimal model was less than that of the original model; the efficiency and the head of optimal model are both higher than those of the original model 4.2 percentage points and 10 m, respectively. The improved efficiency and head can meet the design requirements. The orthogonal testing method has some feasibility to the performance optimization of vortex pump.

引用

页码：101 / 106

页数：5

共 16 条

[1]

Ohba H., Nakashima Y., Shiramoto K., Et al., A study on internal flow and performance of a vortex pump: Part1 theoretical analysis, Bulletin of the JSME, 26, 216, pp. 999-1006, (1983)

[2]

Schivley G.P., An analytical and experimental study of a vortex pump, ASME Journal of Basic Engineering, Ser. D, 92, 4, pp. 889-900, (1970)

[3]

Chen H., Measurement of rotating flow field with in the impeller of vortex pump, Transactions of the Chinese Society for Agricultural Machinery, 27, 1, pp. 49-54, (1996)

[4]

Zheng M., Yuan S., Chen C., Influence of structural parameter of a vortex pump on its performance, Transactions of the Chinese Society for Agricultural Machinery, 31, 2, pp. 46-49, (2000)

[5]

Sha Y., Shi W., Wang Z., Et al., Hydraulic design of non-clogging pump and experimental research on its characters, Transactions of the Chinese Society for Agricultural Machinery, 36, 8, pp. 62-66, (2005)

[6]

Sha Y., Yang M., Kang C., Et al., Design method and characteristic analysis of vortex pump, Transactions of the CSAE, 36, 1, pp. 124-127, (2004)

[7]

Shi W., Wang Y., Kong F., Et al., Numerical simulation of internal flow field with in the volute of vortex pump, Transactions of the CSAE, 21, 9, pp. 72-75, (2005)

[8]

Shi W., Wang Y., Sha Y., Et al., Research on internal flow of a vortex pump, Transactions of the Chinese Society for Agricultural Machinery, 37, 1, pp. 68-70, (2006)

[9]

Xia P., Liu S., Wu Y., Numerical simulation of steady flow in vortex pump, Journal of Engineering Thermophysics, 27, 3, pp. 420-422, (2006)

[10]

Shi W., Sun X., Lu W., Et al., Orthogonal experiment on performance of submersible mining pump, Journal of Drainage and Irrigation Machinery Engineering, 29, 1, pp. 6-10, (2011)

← 1 2 →