Influence of Longitudinal Static Magnetic Field on Microstructure and Microsegregation During Directional Solidification of DD98M Alloy

被引:0
作者
Liu, Xiang [1 ,2 ]
Wang, Yinghao [1 ,2 ]
Zhang, Xiaoxin [1 ,2 ]
Chen, Chaoyue [1 ,2 ]
Meng, Jie [3 ]
Yu, Jianbo [1 ,2 ]
Wang, Jiang [1 ,2 ]
Ren, Zhongming [1 ,2 ]
机构
[1] State Key Laboratory of Advanced Special Steel, Shanghai University, Shanghai
[2] School of Materials Science and Engineering, Shanghai University, Shanghai
[3] Shi-changxu Innovation Center for Advanced Materials, Institute of Metal Research, Chinese Academy of Sciences, Shenyang
来源
Jinshu Xuebao/Acta Metallurgica Sinica | 2024年 / 60卷 / 12期
关键词
DD98M; magnetic field; microsegregation; superalloy; thermoelectric-magnetic convection;
D O I
10.11900/0412.1961.2022.00623
中图分类号
学科分类号
摘要
Nickel-based superalloys have been widely used in gas turbines, aerospace, and other fields owing to their excellent high-temperature strength and creep resistance. Advanced directional-solidification techniques allow crystals to grow along specific directions, which can eliminate most or all of the transverse grain boundaries to obtain columnar- or single-crystal superalloys, which further improve the high-temperature mechanical properties. A strong magnetic field can modify the mass-transfer behavior during solidification via magnetic-damping or thermoelectromagnetic effect without contacting the material, thus improving the microstructure and microscopic segregation. In order to further refine the microstructure of nickel-based single crystal superalloys and improve the degree of homogenization of element distribution, the influence of longitudinal static magnetic field with a magnetic field intensity (B) that ranges from 0 to 4 T on the microstructure and microsegregation of liquid-metal-cooling directionally solidified nickel-based single-crystal superalloy DD98M was investigated. OM and SEM were applied to characterize the microstructure. Microsegregation was evaluated using a microsegregation coefficient and isoconcentration contour maps based on different data collection modes embedded in EDS. The results showed that with an increase in B, the primary dendrite spacing, average size of γ/γ' eutectic organization, and size of the γ' phases decreased. Meanwhile, the γ' phase in the interdendrite became more regularized. The microstructure refinement under static magnetic fields was attributed to the decrease in ΔT' / G (ratio of the temperature difference between the nonequilibrium solid-phase line and dendrite tip to the temperature gradient based on the Kurz-Fisher model) or the increase in sub-cooling of the melt surrounding the dendrites due to thermoelectric-magnetic convection. The relationship between ΔT' / G and B was revealed. The reduction in the γ' phase size was caused by the increase in the nucleation rate of the γ' phase due to the introduction of magnetic free energy difference (ΔGM) under a magnetic field. The magnetic field depressed the microsegregation of solutes, i.e., as B increased, the segregations of Al, Ta, Co, and W decreased. The effective partition coefficient (ke) of the dendritic scale and the average effective partition coefficients of the dendritic and interdendritic areas were obtained. It was found that the decrease in macrosegregation was essentially due to the effective distribution coefficient that approached 1 that due to the magnetic field. © 2024 Chinese Academy of Sciences. All rights reserved.
引用
收藏
页码:1595 / 1606
页数:11
相关论文
共 27 条
  • [21] Influence of the low voltage pulsed magnetic field on the columnar-to-equiaxed transition during directional solidification of superalloy K4169
    Zhang, Kuiliang
    Li, Yingju
    Yang, Yuansheng
    JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY, 2020, 48 : 9 - 17
  • [22] Influence of the low voltage pulsed magnetic field on the columnar-to-equiaxed transition during directional solidification of superalloy K4169
    Kuiliang Zhang
    Yingju Li
    Yuansheng Yang
    Journal of Materials Science & Technology, 2020, 48 (13) : 9 - 17
  • [23] The Change of Mushy-Zone Length of a Nickel-Based Single-Crystal Superalloy During the Static-Magnetic-Field-Assisted Directional Solidification
    Niu, Chunlin
    Ren, Weili
    Ding, Biao
    Zhong, Yunbo
    Yu, Jianbo
    CRYSTAL RESEARCH AND TECHNOLOGY, 2018, 53 (06)
  • [24] Impact of rotating magnetic field on the microstructure, thermal properties, and creep behavior during the solidification of Sn-2.0Ag-0.5Cu solder alloy
    Hammad, A. E.
    El-Molla, Sara
    Ragab, M.
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART L-JOURNAL OF MATERIALS-DESIGN AND APPLICATIONS, 2023, 237 (02) : 317 - 328
  • [25] Influence of assisted longitudinal magnetic field on the microstructure and mechanical properties of ER2319 aluminium alloy parts fabricated by wire and arc additive manufacturing
    Zhang, Xujing
    Zhao, Wenyong
    Long, Jinwei
    Wei, Yanhong
    SCIENCE AND TECHNOLOGY OF WELDING AND JOINING, 2023, 28 (03) : 218 - 225
  • [26] Influence of thermoelectric effects on the solid-liquid interface shape and cellular morphology in the mushy zone during the directional solidification of Al-Cu alloys under a magnetic field
    Li, Xi
    Fautrelle, Yves
    Ren, Zhongming
    ACTA MATERIALIA, 2007, 55 (11) : 3803 - 3813
  • [27] 4D synchrotron X-ray tomographic study of the influence of transverse magnetic field on iron intermetallic compounds precipitation behavior during solidification of Al-Si-Fe alloy
    Cao, Jiawei
    Shuai, Sansan
    Huang, Chenglin
    Hu, Tao
    Chen, Chaoyue
    Wang, Jiang
    Ren, Zhongming
    INTERMETALLICS, 2022, 143