Experiment study on filling imbalance phenomenon of melt front during injection molding process

被引：3
|
作者：
Jiang, Kaiyu [1 ]
Yokoi, Hidetoshi [2 ]
机构：
[1] Key Laboratory for Precision and Non-Traditional Machining Technology, Dalian University of Technology, Dalian 116023, China
[2] Center for Collaborative Research, University of Tokyo, Tokyo 153-8505, Japan
来源：
Jixie Gongcheng Xuebao/Journal of Mechanical Engineering | 2009年 / 45卷 / 02期
关键词：
D O I：
10.3901/JME.2009.02.294
中图分类号：
学科分类号：
摘要：
引用
收藏
页码：294 / 300
相关论文
共 50 条
  • [21] A numerical study of filling process in resin injection/compression molding
    Chang, Chih-Yuan
    JOURNAL OF REINFORCED PLASTICS AND COMPOSITES, 2008, 27 (08) : 781 - 795
  • [22] Intelligent guidance of the melt front in injection molding machines
    Bikas, A
    Pantelelis, N
    Kanarachos, A
    ANTEC 2000: SOCIETY OF PLASTICS ENGINEERS TECHNICAL PAPERS, CONFERENCE PROCEEDINGS, VOLS I-III, 2000, : 751 - 755
  • [23] Study on the influence factors on the filling flow for polymeric melt in micro injection molding
    Key Laboratory for Precision and Non-traditional Machining Technology of Ministry of Education, Dalian University of Technology, Dalian 116024, China
    Suxing Gongcheng Xuebao, 2007, 6 (185-189):
  • [24] Injection velocity control in filling process of injection molding
    Zhongguo Suliao/China Plastics, 2002, 16 (05):
  • [25] Study of polymer melt flow in sequential injection molding process
    Chen, SC
    Chen, NT
    Hsu, KS
    Hsu, KF
    AICHE JOURNAL, 1996, 42 (06) : 1706 - 1714
  • [26] Study of polymer melt flow in sequential injection molding process
    Mechanical Eng Dept, Chung Yuan Univ, Chung-Li 32023, Taiwan
    AIChE J, 6 (1706-1714):
  • [27] Flow visualization of filling process during micro-injection molding
    Yang, SY
    Nian, SC
    Sun, IC
    INTERNATIONAL POLYMER PROCESSING, 2002, 17 (04) : 354 - 360
  • [28] Observation of Instabilities in Flow Front During Micro Injection Molding Process
    Kim, Sun Kyoung
    Choi, Sung-Ju
    Lee, Kwan-Hee
    Kim, Dae-Jin
    Yoo, Yeong-Eun
    POLYMER ENGINEERING AND SCIENCE, 2010, 50 (07): : 1377 - 1381
  • [29] Dynamic simulation of injection molding filling process
    Liu, Chuntai
    Shen, Changyu
    Xiao, Changjiang
    Wan, Lixia
    Yingyong Lixue Xuebao/Chinese Journal of Applied Mechanics, 2002, 19 (03):
  • [30] Numerical simulation of filling flow of polymer melt in injection molding
    Lin, Lanfen
    Ma, Zeen
    Huagong Xuebao/Journal of Chemical Industry and Engineering (China), 1997, 48 (03): : 363 - 368
12345