Effects of coating agents on the ignition and combustion of boron particles

被引：16

作者：

Xi, Jian-Fei ^{[1
]}

Liu, Jian-Zhong ^{[1
]}

Wang, Yang ^{[1
]}

Li, He-Ping ^{[1
]}

Zhang, Yan-Wei ^{[1
]}

Zhou, Jun-Hu ^{[1
]}

Cen, Ke-Fa ^{[1
]}

机构：

[1] State Key Laboratory of Clean Energy Utilization, Zhejiang University

来源：

Guti Huojian Jishu/Journal of Solid Rocket Technology | 2013年 / 36卷 / 05期

关键词：

Boron; Coating; Ignition and combustion; Laser ignition; Thermogravimetry;

D O I：

10.7673/j.issn.1006-2793.2013.05.017

中图分类号：

学科分类号：

摘要：

Boron is an attractive candidate for the development of high-energy fuels. It is important to find ways for promoting ignition and combustion property of boron particles. In this paper, AP, LiF and TMP were used for boron surface coating. Then ignition and combustion behavior of original boron and coated boron were studied by using thermogravimetry coupled with differential scanning calorimetry (TG-DCS) and laser ignition test bench. Results show that the thermal reaction of boron in the air can be divided into three stages: warm-up period, violent reaction period and later reaction period. LiF and TMP can reduce the ignition temperature and increase heat release of the boron samples. AP can slightly raise the ignition temperature and decrease the boron heat release. During laser ignition test, AP can shorten the ignition delay time and improve the combustion intensity. On the other side, LiF and TMP can increase the ignition delay time and lower combustion intensity a little, because they absorb part of the energy from the laser.

引用

页码：654 / 659+665

共 12 条

[1] Ulas A., Kuo K.K., Gotzmer C., Ignition and combustion of boron particles in fluorine-containing environments, Combustion and Flame, 127, 1-2, pp. 1935-1957, (2001)
[2] Pace K.K., Jarymowycz T.A., Yang V., Effect of magnesium-coated boron particles on burning characteristics of solid fuels in high-speed crossflows, International Journal of Energetic Materials and Chemical Propulsion, 2, 1-6, pp. 332-347, (1993)
[3] Trunov M.A., Hoffmann V.K., Schoenitz M., Et al., Combustion of boron-titanium nanocomposite powders in different environments, Journal of Propulsion and Power, 24, 2, pp. 184-191, (2008)
[4] Shyu I.M., Liu T.K., Combustion characteristics of gap-coated boron particles and the fuel-rich solid-propellant, Combustion and Flame, 100, 4, pp. 634-644, (1995)
[5] Liu T.K., Shyu I.M., Hsia Y.S., Effect of fluorinated graphite on combustion of boron and boron-based fuel-rich propellants, Journal of Propulsion and Power, 12, 1, pp. 26-33, (1996)
[6] (1985)
[7] 18, 5, pp. 100-105, (1997)
[8] 7, 6, pp. 6-14, (2009)
[9] 15, 4, pp. 378-381, (2007)
[10] Li S.C., Williams F.A., Takahashi F., An investigation of combustion of boron suspensions, Symposium (International) on Combustion, 22, 1, pp. 1951-1960, (1989)

← 1 2 →