Visualization study and analysis on preform growth in polyethylene terephthalate stretch blow molding

被引：0

作者：

Huang, Han-Xiong ^{[1
]}

Yin, Zhan-Song ^{[1
]}

Liu, Ji-Hu ^{[1
]}

机构：

[1] Center for Polymer Processing Equipment and Intellectualization, College of Industrial Equipment and Control Engineering, South China University of Technology, Guangzhou, China

来源：

Journal of Applied Polymer Science | 2007年 / 103卷 / 01期

关键词：

In stretch blow molding (SBM) process; the preform growth during the stretching and blowing is critical to the thickness distribution and properties of the final bottle. Whereas the thickness distribution is one of the most important criteria in the production of bottles. So this work focused on the polyethylene terephthalate (PET) preform growth using a transparent mold; through which the instantaneous images of the preform in the stretching and blowing stage were captured. By changing the delay time of the preblow; the three preform growth types; referred to as dolphin; sandpile; and two-bubble; were observed. The longitudinal and hoop stresses acting on the preform segment during the stretching and blowing were analyzed. Two parameters; on which the longitudinal and hoop stresses depend; respectively; were defined. Then combining the geometry and sizes of the preform; the stresses and temperature distribution on it; and the stress-strain curves of the PET material used; the cause for different preform growth types was systematically analyzed. On the basis of preform growth types; the thickness distributions of the bottles obtained under different delay times of the preblow were explained. © 2006 Wiley Periodicals; Inc;

D O I：

暂无

中图分类号：

学科分类号：

摘要：

Journal article (JA)

引用

页码：564 / 573