Performance assessment and multi-objective optimization of a novel transcritical CO2 2 Rankine cycle for engine waste heat recovery

被引:6
作者
Xia, Jiaxi [1 ]
Hou, Jingjing [1 ]
Wang, Jiangfeng [2 ]
Lou, Juwei [2 ]
Yao, Sen [1 ]
机构
[1] Henan Agr Univ, Sch Mech & Elect Engn, Zhengzhou 450002, Peoples R China
[2] Xi An Jiao Tong Univ, Sch Energy & Power Engn, State Key Lab Multiphase Flow Power Engn, Xian 710049, Peoples R China
基金
中国国家自然科学基金;
关键词
Engine waste heat recovery; Self-condensing; Economic analysis; Multi-objective optimization; Transcritical CO2 rankine cycle; EXERGOECONOMIC ANALYSIS; THERMODYNAMIC ANALYSIS; WORKING FLUID; POWER CYCLE; SYSTEM; ORC;
D O I
10.1016/j.csite.2024.105223
中图分类号
O414.1 [热力学];
学科分类号
摘要
In this study, a novel self-condensing transcritical CO2 2 Rankine cycle, which integrates the three- stage expansion process with an ejector cycle, is proposed to recover engine waste heat deeply and overcome the condensation issue caused by the relatively low critical temperature of CO2. 2 . Thermodynamic and economic mathematical models are developed, and the detailed parametric analysis is carried out to investigate the effect of main parameters on both thermodynamic and economic performances of the system. Thereafter, a multi-objective optimization is conducted to trade off the two different performances. Results show that the proposed system could operate under higher temperature cold source conditions with desirable performance. The increases of turbine1 inlet pressure and LT gas heater outlet temperature, the decreases of LT gas heater outlet pressure and turbine3 back pressure are beneficial to achieve better thermodynamic and economic performances. On the basis of multi-objective optimization, the maximum net power output is 70.04 kW, which is a 10.20 % improvement compared to the reference cycle. Meanwhile, the engine power output could be increased by 7.03 % through adopting the novel system. Furthermore, the optimal exergy efficiency and unit net power cost are 37.02 % and 0.1567$/kWh, respectively.
引用
收藏
页数:19
相关论文
共 45 条
  • [1] Waste heat utilization from internal combustion engines for power augmentation and refrigeration
    Alklaibi, A. M.
    Lior, N.
    [J]. RENEWABLE & SUSTAINABLE ENERGY REVIEWS, 2021, 152
  • [2] Autier E., 2009, Ifac Proceeding, V45, P132
  • [3] Waste heat recovery of a combined solid oxide fuel cell-gas turbine system for multi-generation purposes
    Cao, Yan
    Zoghi, Mohammad
    Habibi, Hamed
    Raise, Amir
    [J]. APPLIED THERMAL ENGINEERING, 2021, 198
  • [4] Chemaxon, About us
  • [5] An experimental and theoretical study of a CO2 ejector
    Chen Guangming
    Xu Xiaoxiao
    Liu Shuang
    Liang Lixia
    Tang Liming
    [J]. INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2010, 33 (05): : 915 - 921
  • [6] Theoretical research of carbon dioxide power cycle application in automobile industry to reduce vehicle's fuel consumption
    Chen, Y
    Lundqvist, P
    Platell, P
    [J]. APPLIED THERMAL ENGINEERING, 2005, 25 (14-15) : 2041 - 2053
  • [7] Thermodynamic analysis of a transcritical CO2 heat recovery system with 2-stage reheat applied to cooling water of internal combustion engine for propulsion of the 6800 TEU container ship
    Choi, Byung Chul
    [J]. ENERGY, 2016, 107 : 532 - 541
  • [8] Design and multi-criteria optimisation of a trigeneration district energy system based on gas turbine, Kalina, and ejector cycles: Exergoeconomic and exergoenvironmental evaluation
    Ebrahimi-Moghadam, Amir
    Farzaneh-Gord, Mahmood
    Moghadam, Ali Jabari
    Abu-Hamdeh, Nidal H.
    Lasemi, Mohammad Ali
    Arabkoohsar, Ahmad
    Alimoradi, Ashkan
    [J]. ENERGY CONVERSION AND MANAGEMENT, 2021, 227 (227)
  • [9] Proposal and assessment of a novel combined heat and power system: Energy, exergy, environmental and economic analysis
    Ebrahimi-Moghadam, Amir
    Moghadam, Ali Jabari
    Farzaneh-Gord, Mahmood
    Aliakbari, Karim
    [J]. ENERGY CONVERSION AND MANAGEMENT, 2020, 204
  • [10] F.P.D.D. Incropera, 2002, Fundamentals of Heat and Mass Transfer