Experimental study on nondestructive testing of anchor cable in pumped storage power station

被引：0

作者：

Yan L. ^{[1
]}

Zhou L. ^{[2
]}

Cui B. ^{[1
]}

Wang B. ^{[1
]}

Lu J. ^{[1
]}

机构：

[1] Xinjiang Fukang Pumped Storge Power Company Limited, Urumqi

[2] Key Laboratory of Geotechnical Mechanics and Engineering, The Ministry of Water Resources, Changjiang River Scientific Research Institute, Wuhan

来源：

Meitiandizhi Yu Kantan/Coal Geology and Exploration | 2022年 / 50卷 / 08期

关键词：

anchor cable; anchoring quality; elastic wave reflection method; nondestructive testing; wave velocity of anchorage body;

D O I：

10.12363/issn.1001-1986.21.10.0585

中图分类号：

学科分类号：

摘要：

In order to demonstrate the effect of elastic wave reflection method, the nondestructive testing test of anchor cables was carried out at the bank slope of Fukang Pumped Storage Power Station in Xinjiang. On the basis of the basic theory of elastic wave reflection method, the anchor cable sensor is embedded, and the data acquisition, signal excitation position and wave velocity of anchor body in the process of nondestructive testing of anchor cable are systematically studied. The following results are obtained: When the receiving sensor position is fixed and the excitation part is the steel strand where the receiving sensor is installed, the receiving signal amplitude is the largest. When the excitation part is anchor cable tray, the amplitude of the received signal is weakened, but the interference signal is large. The wave velocity of anchor cable decreases with the increase of anchor cable grouting, grouting age and tensile load. According to the experimental test results of anchor cable, the length of anchor cable can be detected and quantitatively analyzed based on elastic wave reflection method. However, at present, elastic wave reflection method can only make qualitative evaluation on grouting tightness of anchor cable anchorage body, which does not reach the accuracy of quantitative evaluation. The experimental results have certain reference and guidance for the peers who study the nondestructive testing technology of anchor cables. © 2022 COAL GEOLOGY & EXPLORATION. All rights reserved.

引用

页码：149 / 156

页数：7

共 19 条

[1]

WANG Junmin, CHEN Yiqun, CHEN Hua, Research on anchor bar quality nondestructive testing technique on highway[J], Progress in Geophysics, 19, 4, pp. 782-785, (2004)

[2]

RAO Xiaoyu, Study on anchorage performance and load transfer mechanism of embedment section of prestressed rock cable bolt, (2007)

[3]

CHEN Xiaodong, ZHONG Jiuan, ZANG Peng, Et al., Calculation and analysis of differential tension of pressure dispersion anchor cables at Lianghekou hydropower station[J], Exploration Engineering (Rock & Soil Drilling and Tunneling), 47, 5, pp. 85-88, (2020)

[4]

MIAO Guohang, XIAN Daqing, CHEN Renjun, Geotechnical anchoring：The “roots” of the prison project: Visiting professor Cheng Liangkui， a well−known expert[J], Geotechnical Engineering World, 6, 11, (2003)

[5]

ZHANG Xianping, Fast pre-stressed anchoring technique for high rocky slope, (2002)

[6]

LIU Minghua, Cause and influence analysis of prestress loss of high slope reinforced by anchor cable[J], Hunan Communication Science and Technology, 45, 3, pp. 16-19, (2019)

[7]

YU Yu, LIU Xinrong, LIU Yongquan, Field experimental investigation on prestress loss law of anchor cable in foundation pits[J], Rock and Soil Mechanics, 40, 5, pp. 1932-1939, (2019)

[8]

LIU Shengdong, ZHANG Pingsong, The dynamic technology of anchoring quality for engineering anchor rod[J], Progress in Geophysics, 19, 3, pp. 568-572, (2004)

[9]

WANG Mingwu, WANG Heling, Nondestructive testing of anchoring quality[J], Chinese Journal of Rock Mechanics and Engineering, 21, 1, (2002)

[10]

LI Qingfeng, LI Xinghua, WU Jingbo, Research of nondestructive test with stress wave on anchor cable quality in coal mine[J], Mining and Metallurgical Engineering, 27, 6, (2007)

← 1 2 →