Performance Evaluation of CO2

This work demonstrates the potential of CO2 + SiCl4 binary mixture as a working fluid for power generation cycle. Recompression Brayton cycle configuration is considered due to its proven record of high performance for medium- to high-temperature sources. The objective of this study is to assess the thermodynamic performance of a recompression Brayton cycle using a CO2 + SiCl4 binary mixture as a working fluid, particularly under warm climate conditions. The cycle is simulated using the Peng-Robinson equation of state in Aspen Hysys (v11) software, and the model is validated by comparing VLE data against experimental data from the literature. The analysis involves the assessment of cycle's thermal efficiency and exergy efficiency under warm climatic conditions, with a minimum cycle temperature of 40 degrees C. The results demonstrate a notable improvement in the cycle's thermodynamic performance with CO2 + SiCl4 binary mixture compared to pure CO2. A small concentration (5%) of SiCl4 in CO2 increases the thermal efficiency of the cycle from 41.7% to 43.4%. Moreover, irreversibility losses in the cooler and the heat recovery unit are significantly lower with the CO2 + SiCl4 binary mixture than with pure CO2. This improvement enhances the overall exergy efficiency of the cycle, increasing it from 62.1% to 70.2%. The primary reason for this enhancement is the substantial reduction in irreversibility losses in both the cooler and the HTR. This study reveals that when using a CO2 + SiCl4 mixture, the concentration must be optimized to avoid condensation in the compressor, which can cause physical damage to the compressor blades and other components, as well as increase power input. This issue arises from the higher glide temperature of the mixture at increased SiCl4 concentrations and the limited heat recovery from the cycle.