A fault arc detection method of a small current grounding system based on VMD-CNN

被引：0

作者：

Cui P. ^{[1
,2
]}

Li G. ^{[1
,3
]}

Zhang Q. ^{[1
,4
]}

Fan M. ^{[5
]}

Zhang Y. ^{[6
]}

机构：

[1] School of Electrical Engineering and Automation, Anhui University, Hefei

[2] Engineering Research Center of Power Quality, Ministry of Education, Hefei

[3] Anhui Key Laboratory of Industrial Energy-Saving and Safety, Anhui University, Hefei

[4] Anhui Collaborative Innovation Center of Industrial Energy-Saving and Power Quality Control, Anhui University, Hefei

[5] State Grid Anhui Electric Power Co., Ltd. Research Institute, Hefei

[6] Anhui BEIDOU E-TOP Information Technology Co., Ltd., Hefei

来源：

Dianli Xitong Baohu yu Kongzhi/Power System Protection and Control | 2021年 / 49卷 / 23期

基金：

中国国家自然科学基金;

关键词：

Arc model; Convolution neural network; Fault diagnosis; Variational mode decomposition;

D O I：

10.19783/j.cnki.pspc.211222

中图分类号：

学科分类号：

摘要：

An accurate and consistent arc model under specific scenes is built. It is important to identify a fault arc in a timely and reliable fashion by studying the current signal characteristics of arc small current grounding and processing it based on the measurable electrical volume signal. A detection method for a fault arc in a small current grounding system is proposed. By establishing the fault arc model, the fault arc is accurately identified based on variational mode decomposition and a convolution neural network. First, the improved "cybernetic" arc model is adopted, and a typical 10 kV distribution network simulation model and the grounding "cybernetic" arc model are built on the PSCAD software platform. Secondly, the variational mode decomposition algorithm is used to process the electrical signal in the fault state, and the Intrinsic Mode Function (IMF) of current signals of four groups is obtained. Then, the first set of IMF (IMF1) containing the signal fundamental frequency components is extracted as the input to the Convolutional Neural Network (CNN). Finally, CNN is used to identify the characteristics of IMF1 and correctly identify the normal and arc fault situations. The experimental and simulation results show that the VMD-CNN identification method improves the accuracy of identifying the original current signal and accurately detects the fault arc. © 2021 Power System Protection and Control Press.

引用

页码：18 / 25

页数：7

共 27 条

[11] TANG Yingsong, ZENG Xianwen, GAO Guige, Modeling and simulation analysis of high voltage grounding fault arc based on EMTP, Journal of Shanghai Institute of Electrical Engineering, 21, 3, pp. 41-47, (2018)
[12] GAO Wei, YANG Gengjie, GUO Moufa, Et al., Internal overvoltage type identification for distribution network based on DTCWT-DBN algorithm, Power System Protection and Control, 47, 9, pp. 80-89, (2019)
[13] LI Xinyue, LI Fengting, YIN Chunya, Et al., Transient overvoltage calculation method of HVDC sending-end system under DC bipolar blocking, Power System Protection and Control, 49, 1, pp. 1-8, (2021)
[14] LIU Zhanlei, ZENG Xiangjun, YU Kun, Et al., A new method of single-phase grounding fault protection for a resonant grounding distribution network based on unbalanced overvoltage dynamic suppression, Power System Protection and Control, 49, 8, pp. 42-49, (2021)
[15] BORISOV R K, SMIRNOV M N, GOLDUN A V, Et al., An experimental study of high-frequency overvoltage spikes, Russian Electrical Engineering, 92, 4, pp. 181-184, (2021)
[16] REN Wei, LI Shurong, XUE Yongduan, Simulation analysis of influence of inverter interfaced distributed generator access on arc grounding overvoltage of distribution network, Distribution & Utilization, 36, 2, pp. 13-19, (2019)
[17] MA Zutao, LI Shurong, Modeling and analysis of low current grounding fault arc, Proceedings of the CSU-EPSA, 33, 9, pp. 103-108, (2021)
[18] LI Shurong, XUE Yongduan, XU Bingyin, Arc modeling and overvoltage analysis of low current earth fault, Journal of Electric Power Science and Technology, 34, 1, pp. 47-53, (2019)
[19] WANG Menghao, LI Kaicheng, LIU Chang, Et al., Prony-GSO joint harmonic detection method based on improved VMD denoising, Electrical Measurement & Instrumentation, 57, 24, pp. 102-107, (2020)
[20] ZHAI Erjie, SHU Zhengyu, WANG Jun, Fault line selection method of small current grounding system based on VMD-LSTM, Advanced Technology of Electrical Engineering and Energy, 40, 1, pp. 70-78, (2021)

← 1 2 3 →