Preparation of microfibrous supported silicalite-1 zeolite membrane by secondary growth method

被引：0

作者：

Liu, Jian ^{[1
]}

Yan, Ying ^{[2
]}

Zhang, Hui-Ping ^{[2
]}

机构：

[1] Key Laboratory of Functional Organometallic Materials of Hunan Province College, Hengyang Normal University, Hengyang

[2] School of Chemistry and Chemical Engineering, South China University of Technology, Guangzhou

来源：

Gao Xiao Hua Xue Gong Cheng Xue Bao/Journal of Chemical Engineering of Chinese Universities | 2015年 / 29卷 / 02期

关键词：

Anodic oxidation method; Crystallization temperature; Crystallization time; Secondary growth method; Stainless steel fiber; Zeolite membrane;

D O I：

10.3969/j.issn.1003-9015.2015.02.029

中图分类号：

学科分类号：

摘要：

Stainless steel microfibrous supported silicalite-1 zeolite membrane (silicalite-1 membrane/SMF) was prepared by secondary growth method from TEOS as Si source. The effects of different operation parameters such as support pretreatment methods, crystallization temperature and crystallization time on the silicalite-1 membrane/SMF were studied. The morphology and microstructure of silicalite-1 membrane/SMF were characterized by XRD, SEM and ASAP-2020 automatic adsorption instrument, respectively. The results show that the silicalite-1 zeolite membrane prepared by treating support with anodic oxidation method is more continuous and denser than that with calcinations. The surface of zeolite membrane is much denser and the size of crystal grains increases with increasing the crystallization temperature from 100℃ to 160℃ or prolonging the crystallization time from 12h to 96h. The specific surface areas, total pore volume and micropore volume of the silicalite-1 membrane/SMF are 93.24 m2·g-1, 0.0654 cm3·g-1 and 0.0382 cm3·g-1, respectively. The percentage of micropore volume is 58% of total pore volume. The silicalite-1 membrane content determined for silicalite-1/SMF composite is 23.3 %(wt). ©, 2015, Zhejiang University. All right reserved.

引用

页码：432 / 437

页数：5

共 16 条

[1]

Othman M.R., Tan S.C., Bhatia S., Separability of carbon dioxide from methane using MFI zeolite-silica film deposited on gamma-alumina support, Microporous and Mesoporous Materials, 121, 1-3, pp. 138-144, (2009)

[2]

Kong C.L., Lu J.M., Yang J.H., Et al., Preparation of silicalite-1 membranes on stainless steel supports by a two-stage varying-temperature in situ synthesis, Journal of Membrane Science, 285, 1-2, pp. 258-264, (2006)

[3]

Luo M., Wang Z., Wang Y., Et al., Oriented ZSM -5 zeolite membranes on biomorphic SiSiC ceramics for microreactors, Journal of Inorganic Materials, 24, 2, pp. 330-334, (2009)

[4]

Zhang X.-F., Liu H.-O., Wang A.-J., Et al., Factors affecting the formation of zeolite seed layers on different porous supports and effects of seed layers on the growth of zeolite membranes, J Chem Eng of Chinese Univ, 20, 4, pp. 520-526, (2006)

[5]

Faisal A., Zarebska A., Saremi P., Et al., MFI zeolite as adsorbent for selective recovery of hydrocarbons from ABE fermentation broths, Adsorption, 20, 2-3, pp. 465-470, (2014)

[6]

Wang Z., Hedlund J., Sterte J., Synthesis of thin silicalite-1 films on steel supports using a seeding method, Microporous and Mesoporous Materials, 52, 3, pp. 191-197, (2002)

[7]

Shu X.J., Wang X.R., Kong Q.Q., Et al., High-flux MFI zeolite membrane supported on YSZ hollow fiber for separation of ethanol/water, Industrial & Engineering Chemistry Research, 51, 37, pp. 2073-2080, (2012)

[8]

Shen D., Xiao W., Yang J.H., Et al., Synthesis of silicalite-1 membrane with two silicon source by secondary growth method and its pervaporation performance, Separation and Purification Technology, 76, 3, pp. 308-315, (2011)

[9]

Ahn H., Jeong D., Jeong H.K., Et al., Pervaporation characteristics of trichlorinated organic compounds through silicalite-1 zeolite membrane, Desalination, 245, 1-3, pp. 754-762, (2009)

[10]

Zhang X.L., Zhu M.H., Zhou R.F., Et al., Synthesis of silicalite-1 membranes with high ethanol permeation in ultradilute solution containing fluoride, Separation and Purification Technology, 81, 3, pp. 480-484, (2011)

← 1 2 →