Static characteristics of a novel flux-switching permanent magnet linear motor

被引：2

作者：

Huang L. ^{[1
,2
]}

Yu H. ^{[1
,2
]}

Hu M. ^{[1
,2
]}

Zhou S. ^{[1
,2
]}

Liu H. ^{[1
,2
]}

机构：

[1] School of Electrical Engineering, Southeast University

[2] Engineering Research Center for Motion Control of Ministry of Education, Southeast University

来源：

Journal of Southeast University (English Edition) | 2011年 / 27卷 / 01期

关键词：

Finite element method; Flux-switching; Permanent magnet linear motor; Static characteristics;

D O I：

10.3969/j.issn.1003-7985.2011.01.006

中图分类号：

学科分类号：

摘要：

A novel flux-switching permanent magnet linear motor(FSPMLM) is proposed for linear direct driving machine tools. First, the two- and three-dimensional topological configuration of the proposed motor is presented; the basic operational principle of the FSPMLM is introduced; and the magnetic fields at the two typical conditions of no-load are analyzed. Secondly, the FSPMLM is analyzed by the two-dimensional finite element method(FEM) to investigate the static electromagnetic characteristics such as flux-linkage, back EMF(electromotive force) and inductance performances. The cogging forces of two kinds of FSPMLMs with different shaped cores are analyzed and compared, and the results show that the cogging force is significantly reduced by using the E-shaped cores. Additionally, based on the co-energy method, the thrust equation is derived and verified by the simulation results obtained by the FEM. Finally, an experimental prototype is used to test the characteristics under open circuit and load conditions. The simulation and experimental results indicate that the proposed motor has advantages of a sinusoidal back-EMF waveform, a small cogging effect and a high thrust density, and it is suitable for the application of linear direct driving machine tools.

引用

页码：26 / 30

页数：4

共 11 条

[1]

Nasar S.A., Boldea I., Linear Motor Electric Machines, pp. 1-30, (1976)

[2]

Isfahani A.H., Ebrahimi B.M., Lesani H., Design optimization of a low-speed single-sided linear induction motor for improved efficiency and power factor, IEEE Transactions on Magnetics, 44, 2, pp. 266-272, (2008)

[3]

Stumberger G., Zarko D., Aydemir M., Et al., Design and comparison of linear synchronous motor and linear induction motor for electromagnetic aircraft launch system, IEEE International Electric Machines and Drives Conferences, pp. 494-500, (2003)

[4]

Rauch S.E., Johnson L.J., Design principle of flux-switching alternator, AIEE Transactions, 74, 3, pp. 1261-1268, (1955)

[5]

Wang C.F., Shen J.X., Wang L.L., Et al., A novel permanent magnet flux-switching linear motor, The Fourth IET Conference on Power Electronics, Machines and Drives, pp. 116-119, (2008)

[6]

Zhu Z.Q., Chen X., Chen J.T., Et al., Novel linear flux switching permanent magnet machines, International Conference on Electrical Machines and Systems, pp. 2948-2953, (2008)

[7]

Wang C., Shen J., Wang Y., Et al., A new method for reduction of detent force in permanent magnet flux-switching linear motors, IEEE Transactions on Magnetics, 45, 6, pp. 2843-2846, (2009)

[8]

Jin M., Wang C., Shen J., Et al., A modular permanent magnet flux-switching linear machine with fault tolerant capability, IEEE Transactions on Magnetics, 45, 8, pp. 3179-3186, (2009)

[9]

Hua W., Cheng M., Inductance characteristics of 3-phase flux-switching permanent magnetic machine with doubly-salient structure, Transactions of China Electrotechnical Society, 22, 11, pp. 21-28, (2007)

[10]

Zhu Z.Q., Thomas A.S., Chen J.T., Et al., Cogging torque in flux-switching performance magnet machines, IEEE Transactions on Magnetics, 45, 10, pp. 4708-4711, (2009)

← 1 2 →