Influence of aerodynamic effect of wings on high-speed trains passing through tunnels

被引：0

作者：

Wang, Tiantian ^{[1
,2
]}

Huang, Dafei ^{[1
]}

Wang, Yu ^{[2
]}

Wang, Junyan ^{[2
]}

Shi, Fangcheng ^{[1
]}

Zhu, Yan ^{[3
]}

Zhang, Lei ^{[2
]}

机构：

[1] College of Mechanical and Vehicle Engineering, Hunan University, Changsha

[2] School of Traffic & Transportation Engineering, Central South University, Changsha

[3] CRRC Changchun Railway Vehicles Co. Ltd., Changchun

来源：

Zhongnan Daxue Xuebao (Ziran Kexue Ban)/Journal of Central South University (Science and Technology) | 2024年 / 55卷 / 05期

基金：

中国国家自然科学基金;

关键词：

blockage ratio; high-speed train; micro-pressure wave; pressure; tunnel; wing;

D O I：

10.11817/j.issn.1672-7207.2024.05.004

中图分类号：

学科分类号：

摘要：

Integrating wings with high-speed trains can alleviate the downward pressure exerted on the track, subsequently decrease wear and tear. However, wings seriously influence the aerodynamic performance of high-speed train when high-speed train passes through tunnels. RNG k−ε equation turbulence model was employed to simulate the aerodynamic effects caused by high-speed trains with wings(HSTW) passing through tunnels. The results show that when the train enters the tunnel, the wing tail vortex field structure grows, which affects the train surface pressure. The wake of the wings decrease pressure on the train surface, while the wings increase the train/ tunnel area ratio, which increases the pressure on the train surface. Both of them affect the pressure on the train surface, forming a complex pressure distribution on the train surface. The additional wings increase the pressure magnitude on both the train surface and the tunnel wall, with the maximum increase of 5.4% on train surface and 14.1% on tunnel wall. The wings also adversely affect the micro-pressure wave, and the amplitude of the micro-pressure wave at a distance of 20 m from the tunnel exit increases by 4.1%. The results can provide guidance for the design of wing parameters. © 2024 Central South University of Technology. All rights reserved.

引用

页码：1702 / 1712

页数：10

共 29 条

[1] SUI Shuqi, WANG Kaiyun, LING Liang, Et al., Effect of wheel diameter difference on tread wear of freight wagons, Engineering Failure Analysis, 127, 1, (2021)
[2] YIN Xianxian, WEI Xiukun, XIAO Hong, Et al., The impact of wheel polygonisation to the railway corrugation[J], Vehicle System Dynamics, 60, 8, pp. 2636-2657, (2022)
[3] HOU Maorui, CHEN Bingzhi, CHENG Di, Study on the evolution of wheel wear and its impact on vehicle dynamics of high-speed trains, Coatings, 12, 9, (2022)
[4] LIU Jihua, JIANG Wenjuan, CHEN Shuiyou, Et al., Effects of rail materials and axle loads on the wear behavior of wheel/rail steels, Advances in Mechanical Engineering, 8, 7, (2016)
[5] MISTRY P J, JOHNSON M S., Lightweighting of railway axles for the reduction of unsprung mass and track access charges, Proceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 234, 9, (2020)
[6] ISHIZUKA T, KOHAMA Y, KATO T, Et al., Experimental investigations on the ground effect characteristics of the U-shaped and V-shaped wing designs for the aero-train, Transactions of the Japan Society of Mechanical Engineers: Part B, 72, 717, (2006)
[7] YOON D H, KOHAMA Y, KIKUCHI S, Et al., Improvement of aerodynamic performance of the aero-train by controlling wing-wing interaction using single-slotted flap, JSME International Journal Series B, 49, 4, (2006)
[8] LAI Chenguang, REN Boqi, YAN Zhigang, Et al., Optimization and wing-in-ground analysis on Aero-train unidirectional-wing, Acta Aerodynamica Sinica, 35, 1, (2017)
[9] WANG Ruidong, NI Zhangsong, ZHANG Jun, Et al., Optimization design of tandem airfoils on high-speed train [J], Acta Aerodynamica Sinica, 40, 2, (2022)
[10] YAN Rihua, GAO Chao, WU Bin, Et al., Research on aerodynamic layout of lift wings on a high-speed train under boundary constraint, Acta Aerodynamica Sinica, 40, 6, (2022)

← 1 2 3 →