An experimental study of a collector and diffuser system on a small demonstration wind turbine

被引:13
作者
Department of Electrical and Computer Engineering, School of Engineering and Architecture, Lebanese American University, PO Box 36, Byblos, Lebanon [1 ]
不详 [2 ]
机构
[1] Department of Electrical and Computer Engineering, School of Engineering and Architecture, Lebanese American University, Byblos
[2] Department of Mechanical Engineering, School of Engineering and Architecture, Lebanese American University
来源
Int. J. Mech. Eng. Educ. | 2008年 / 1卷 / 58-68期
关键词
Collector; Diffuser; Power augmentation ration; Wind turbine;
D O I
10.7227/IJMEE.36.1.6
中图分类号
学科分类号
摘要
A diffuser-augmented wind turbine (DAWT) has been an attractive concept of wind energy extraction since the early 1970s, due to the system's ability to increase the power generated by a regular bare turbine of the same size. However, the DAWT needs to reach a minimum augmentation ratio of 4 in order to become economically feasible. This paper investigates the possible improvement of a DAWT system by adding a collector fuselage to increase its augmentation ratio. Testing using a small experimental unit shows that adding a collector increases the power augmentation of the DAWT by more than 50%, and increases the mass flow rate through the turbine by increasing the effective upstream area of the wind that enters it. Changing the angle of the incident wind on a collector- and diffuser-augmented wind turbine (CDAWT) shows that it is possible to capture the energy in the wind up to an angle of 71°. Moreover, the CDAWT can keep extracting wind energy, without any diminution of the augmentation ratio, as wind direction varies ±45° from the turbine axes, thus eliminating the requirement for a yaw mechanism. Hence, the variant wind direction has a positive effect on the augmentation ratio.
引用
收藏
页码:58 / 68
页数:10
相关论文
共 4 条
  • [1] Foreman K.M., Gilbert B.L., Oman R.A., Diffuser augmentation of wind turbines, Solar Energy, 20, pp. 305-311, (1977)
  • [2] Oman R.A., Forman K.M., Gilbert B.L., Investigation of diffuser augmented wind turbines, Part II, Technical Report, ERDA Report C00-2616-2, (1977)
  • [3] Foreman K.M., Gilbert B.L., Technical development of the diffuser augmented wind turbine (DAWT) concept, Wind Engineering, 3, 3, (1979)
  • [4] Igra O., Shrouds for Aero Generator, Report No. 2, (1975)