The influence of finishing strategy on the quality of surface

被引：0
作者：
Hnátík J. [1 ]
机构：
[1] University of West Bohemia, Univerzitní 8, Pilsen
来源：
Kroft, Luboš (kroft@rti.zcu.cz) | 2018年 / Trans Tech Publications Ltd卷 / 919期
关键词：
Ball nose end mill; CAM systems; Constant cutting speed; Finishing; Machining efficiency; Surface quality;
D O I：
10.4028/www.scientific.net/MSF.919.18
中图分类号：
学科分类号：
摘要：
The present contribution focuses on finishing operations in machining. Finishing operations belong to the most time-consuming and surface quality-critical machining tasks. High-quality tools are available nowadays for choosing optimal tool paths for finishing. Yet, the finishing options for general shaped surfaces are still severely limited. Although CAM systems can efficiently generate tool paths, none of them offers the combination of finishing tool paths, modern productive methods and adaptive tool paths. Increasing the productivity while maintaining dimensional accuracy and the quality of finished surfaces is the key point in finishing. One of the ways to improving productivity is the use of constant cutting speed. The aim of this article is to present experimental verification of these assumptions and demonstrate the impact on the quality of the finished surface. © 2018 Trans Tech Publications, Switzerland.
引用
收藏
页码：18 / 24
页数：6
相关论文
共 7 条
  • [1] HSR/HSM Modules for 3D High-Speed Machining/HSR/HSM Moduly Pro 3D vysokorychlostní obrábění [Online]
  • [2] Ren W.J., He J.Y., Yu Y., Tool Path Scheduling for Free-Form Surface Based on MasterCAM, Applied Mechanics and Materials, 556-562, pp. 1400-1403, (2014)
  • [3] Zuperl U., Cus F., Reibenschuh M., Neural Control Strategy of Constant Cutting Force System in End Milling [Online], (2010)
  • [4] Clem P.G., Rodriguez M., Voigt J.A., Ashley C.S., (2001)
  • [5] Czerech L., Selection of Optimal Machining Strategy in the Manufacture of Elements Bounded by Curvilinear Surfaces, Acta Mechanica Et Automatica, 7, 1, pp. 5-10, (2013)
  • [6] Sova F., Hamouz L., Softwarová optimalizace dráhy frézovacího nástroje při práci na čisto, Strojírenská Technologie - Plzeň 2004. Plzeň: University of West Bohemia, pp. 1-15, (2004)
  • [7] Andrlik J., Návrh strategie dokončování tvarových ploch, Plzeň, (2017)
1