Experimental study on the mode conversion of lamb waves in a metal plate of stepped thickness using optical detection

被引：1

作者：

Imano K. ^{[1
]}

机构：

[1] Department of Electrical and Electronic Engineering, Faculty of Engineering and Resource Science, Akita University, Akita 010-8502

来源：

International Journal of the Society of Material Engineering for Resources | 2010年 / 17卷 / 02期

关键词：

Lamb wave; Mode conversion; Non-destructive evaluation (NDE); Optical detection;

D O I：

10.5188/ijsmer.17.201

中图分类号：

学科分类号：

摘要：

The optical observation of the propagation of Lamb waves in an aluminum plate with stepped thickness is described. Lamb waves passing through the aluminum plate were analyzed by two-dimensional Fourier transformation to discriminate modes and thus determine mode conversion. S0-mode and A0-mode Lamb waves corresponding to theoretical dispersion curves were experimentally found to propagate in the aluminum plate. Conversion from A0-mode to S0-mode waves at the thickness step was also observed. This mode conversion of Lamb waves is thus a useful index for detecting defects such as ablation, wear and wall reduction. © 2010 Soc. Mater. Eng. Resour.

引用

页码：201 / 204

页数：3

共 10 条

[1]

Nishino H., Fundamental and application of ultrasonic guided wave for nondestructive inspection, Hihakai Kensa, 52, 12, pp. 654-661, (2003)

[2]

Wilcox P., Evans M., Pavlakovic G., Alleyne D., Vine K., Cawley P., Lowe M., Guided wave testing of rail, Insight, 45, 6, pp. 413-420, (2003)

[3]

Hayashi T., Kawashima K., Multiple reflections of Lamb waves at a delamination, Ultrasonics, 40, 1-8, pp. 193-197, (2002)

[4]

Imano K., A tilted angle polarization type piezoelectric transducer for plate wave generation, IEICE Electronics Express, 4, 10, pp. 340-343, (2007)

[5]

Watanabe M., Nishihira M., Imano K., Detection of defects on reverse side of metal plate using MHz-range air-coupled Lamb wave, Japanese Journal of Applied Physics, Part 1: Regular Papers and Short Notes and Review Papers, 45, 5 B, pp. 4565-4568, (2006)

[6]

Imano K., Kondou M., Possibilities of nondestructive evaluation of a pipe using air-coupled ultrasonic wave in the MHz range, IEICE Electronics Express, 5, 17, pp. 668-671, (2008)

[7]

Alleyne D.N., Cawley P., The interaction of lamb waves with defects, IEEE Trans. Ultrason. Ferroelectr. And Freq. Control, 39, 3, pp. 381-397, (1992)

[8]

Morvan B., Wilkie-Chancellier N., Duflo H., Tinel A., Duclos J., Lamb wave reflection at the free edge of a plate, Journal of the Acoustical Society of America, 113, 3, pp. 1417-1425, (2003)

[9]

Marical P., Ech-Cherif El-Kettani M., Predoi M.V., Guided waves in elastic plates with Gaussian section variation: Experimental and numerical results, Ultrasonics, 47, 1-4, pp. 1-9, (2007)

[10]

Alleyne D., Cawley P., A two-dimensional fourier transform method for the measurement of propagating multimode signals, J. Acoust. Soc. Am., 89, 3, pp. 1159-1168, (1991)

← 1 →