3D Melt Blowing of Elastollan Thermoplastic Polyurethane for Tissue Engineering Applications: A Pilot Study

Scaffolds, in addition to being biocompatible, should possess structural and mechanical properties similar to the natural tissues they intend to replace. Many tissue engineering applications require porous 3D scaffolds characterized by unique microfibrous organization and mechanical anisotropy. Manufacturing process principles and process parameter-biomaterial interactions ultimately govern the properties that can be achieved in the scaffold. In this study, we investigate a recently developed nonwoven scaffold fabrication process, 3D melt blowing (3DMB), for processing Elastollan (R), a thermoplastic polyurethane with basic mechanical properties suitable for musculoskeletal tissue engineering. The range of feasible processing parameters was screened and the effects of two sets of critical process parameters (fiber deposition offset and surface velocity of the collector) that produced contrasting scaffold morphologies were assessed. Results showed that scaffolds of Group B that were fabricated at the higher fiber deposition offset (90%) and higher surface velocity of the collector (6x10(5) mm/min) possessed significantly smaller fiber diameter and higher porosity and degree of fiber alignment along the principal direction of collector rotation during 3DMB (all p<0.05) compared to Group A scaffolds (fabricated at 50% offset and 1x10(5) mm/min surface velocity). Although both groups possessed similar tensile stiffness, the elongation at failure was significantly different ( p<0.0001). The higher elongation at failure of Group B correlated with the higher degree of fiber alignment in these scaffolds. In contrast, the more isotropic fibrous organization of Group A contributed to their higher compressive stiffness (p=0.004). The introduction of NaOH treatment to improve hydrophilicity of the scaffolds resulted in a significant reduction of tensile stiffness of Group A (p<0.05) but not Group B. This treatment did not significantly affect the elongation at failure or compressive stiffness of both groups. With NaOH-treatment, both groups demonstrated good biocompatibility when seeded with fibroblast cells over 14 days. This study confirms the ability to fabricate via 3DMB, biocompatible, micro-fibrous, Elastollan scaffolds relevant for musculoskeletal tissue engineering.