Measurement method and accumulation characteristics of surface charge distribution on polymeric material under DC voltage

被引：0
|
作者：
Zhang B. [1 ]
Wang Q. [2 ]
Qi Z. [1 ]
Zhang G. [1 ]
机构：
[1] State Key Lab of Control and Simulation of Power System and Generation Equipment, Dept. of Electrical Engineering, Tsinghua University, Haidian District, Beijing
[2] School of Mechatronic Engineering, Beijing Institute of Technology, Haidian District, Beijing
来源：
Zhang, Guixin (guixin@mail.tsinghua.edu.cn) | 1600年 / Chinese Society for Electrical Engineering卷 / 36期
关键词：
Charge accumulation; Electrostatic probe; Epoxy resin; Gas-insulated line; Gas-insulated line (GIL); HVDC; Surface charge; Wiener filter;
D O I：
10.13334/j.0258-8013.pcsee.161815
中图分类号：
学科分类号：
摘要：
Charge accumulation on a solid insulator surface is one of the critical factors for the development of dc gas-insulated equipment since it will lead to the overstress of polymeric insulation due to local field distortion and enhancement. Therefore, it is significant to study the charge accumulation phenomenon on spacer surface under dc field. However, it remains an important subject to obtain the accurate results of surface charge distribution. Electrostatic probe method was used to measure the surface potential distribution of a cone-shaped spacer in a downsized gas-insulated line (GIL) and the inverse calculation method of the surface charge distribution, especially for this "shift-variant" configuration, was investigated. Numerical simulation was used to obtain the transfer matrix from charge density to the probe output. By a signal processing technique based on the Wiener filter, the ill-condition problem of the matrix was solved and the stability of the calculation was improved. The study also analyzed the spatial resolution and accuracy of the calculation results, which shows that the spatial resolution of the system can reach 1.8 mm. Based on the above method, we studied the charge accumulation phenomena of the epoxy spacer under dc voltage in air and SF6. The results show that there are two patterns in the charge distribution: "dominant uniform charging" and random "charge speckles". The uniform charging was of the same polarity as the applied voltage, which indicates current flow from the solid bulk is the dominate mechanism in surface charging. © 2016 Chin. Soc. for Elec. Eng.
引用
收藏
页码：6664 / 6674
页数：10
相关论文
共 32 条
  • [1] Zhang W., Zhou X., Guo J., Et al., Feasibility of ±1000kV ultra HVDC in the power grid of China, Proceedings of the CSEE, 27, 28, pp. 1-5, (2007)
  • [2] Koch H., Gas Insulated Transmission Lines(GIL), pp. 1-5, (2011)
  • [3] Akimov V.V., Varivodov V.N., Volpov E.K., An approach to the spacer design of HVDC SF<sub>6</sub> gas insulated equipment, Proceedings of the 3rd IEEE International Conference on Properties and Applications of Dielectric Materials, pp. 525-528, (1991)
  • [4] Kumara S., Serdyuk Y.V., Gubanski S.M., Simulation of surface charge effect on impulse flashover characteristics of outdoor polymeric insulators, IEEE Transactions on Dielectrics and Electrical Insulation, 17, 6, pp. 1754-1763, (2010)
  • [5] Faircloth D.C., Allen N.L., High resolution measurements of surface charge densities on insulator surfaces, IEEE Transactions on Dielectrics and Electrical Insulation, 10, 2, pp. 285-290, (2003)
  • [6] Kumada A., Okabe S., Measurement of surface charge on opposite sides of a planar insulator using an electrostatic probe, IEEE Transactions on Dielectrics and Electrical Insulation, 11, 6, pp. 919-928, (2004)
  • [7] Ding L., Tu Y., Li C., Et al., Measurement of the charge distribution on the insulator surface in vacuum, High Voltage Engineering, 29, 4, (2003)
  • [8] Wang F., Qiu Y., Pfeiffer W., Et al., Insulator surface charge accumulation under impulse voltage, IEEE Transactions on Dielectrics and Electrical Insulation, 11, 5, pp. 547-854, (2004)
  • [9] Takuma T., Yashima M., Kawamoto T., Principle of surface charge measurement for thick insulating specimens, IEEE Transactions on Dielectrics and Electrical Insulation, 5, 4, pp. 497-504, (1998)
  • [10] Wang D., Tang J., Tao J., Et al., Surface charge accumulation characteristics on polymer after flashover and corona charging under dc voltage, High Voltage Engineering, 41, 11, pp. 3618-3627, (2015)
1234